Milwaukee Tool 48-32-2301 11PC SHOCKWAVE, 30° KNUCKLE, Pivoting Bit Holder

Yes. The Shockwave 48-32-2301 holder has a 1/4 inch hex Power Groove shank, which drops straight into quick connect chucks on impact drivers and drill/drivers that take 1/4 inch hex accessories.

The knuckle locks at either 0 degrees for straight driving or 30 degrees for off-axis work, so you can drive fasteners where the driver body won't clear, like inside a panel, behind ductwork, or in a cabinet corner. Because it locks rather than floating, the bit stays on the angle you set instead of wandering under torque.

It's rated to 2,000 in/lbs of torque, built from heat treated steel with Milwaukee's proprietary steel and heat treat process. That rating is what matters if you're running it on a high-torque impact driver all day rather than a drill.

The holder is 5 inches long. Add that to your driver's nose and plan clearance accordingly, though the point of the 30 degree locking knuckle is that you can angle it rather than needing straight-on depth.

A 30 degree locking knuckle like the Shockwave 48-32-2301 is for openings where you can get close but not square to the fastener, and it keeps the full torque path of a 1/4 inch hex shank (rated 2,000 in/lbs). If you need to drive a fastener truly perpendicular to the tool in a wall cavity or joist bay, a 90 degree right angle drive attachment is the correct tool instead; 30 degrees won't get you there.

There's a strong magnetic tip for fastener retention, so it holds the insert bit and keeps a screw seated on it. That's what makes one-handed starts possible when you're reaching into a box or working overhead.

It's an 11 piece Shockwave kit built around the 30 degree knuckle pivoting bit holder, which accepts standard 1/4 inch hex insert bits. Ordering it gets you the holder plus the accompanying Shockwave pieces as one part number, 48-32-2301.