American Standard Princeton Americast 60 x 30-Inch Integral Apron Bathtub Above Floor Rough with Left-Hand Outlet - AMS-2392202

The Princeton 2392202 is the left-hand outlet version. Stand facing the tub from the room side, looking at the apron: the drain and overflow are at the left end. If your rough-in drain sits at the right end as you face the apron, you need the right-hand outlet model instead, not this one. The tub itself is 60 x 30 inches with an integral apron front.

Above floor rough means the waste and overflow plumb in the space directly under the tub rather than below the subfloor, so you do not have to relocate or cut in a new drain below. That is the reason this version gets specified on slab construction and on remodels where breaking the floor is not practical. On a slab you still need the drain stub in the right spot, but the trap and connection sit above the floor line under the tub deck.

It is built as an alcove tub. There is one integral apron on the long front side and a tiling flange on the back and end walls, which means it is meant to drop into a three-wall recess with the flange buried behind the wallboard and tile. The ends are unfinished, so it will not look right freestanding or with an end left open to the room. For a corner or peninsula layout you want a tub finished on two sides.

Yes. The Princeton Americast apron bathtub is stated to meet Americans with Disabilities Act requirements, which is why it turns up on hospitality and institutional specs. The bathing surface is also StanSure slip-resistant, a textured finish on the floor of the tub that still wipes clean. Grab bars and controls are separate items and have their own ADA placement rules.

Americast is American Standard's bonded material with a steel core layer and a composite backing, finished in porcelain enamel. Against cast iron, it carries far less dead weight for the same porcelain enamel surface and the backing insulates rather than pulling heat out of the bathwater. Against a plain enameled steel tub, the backing damps the drumming noise you get when the shower runs. For fleet work, the non-porous glossy enamel is the part that matters day to day: it resists scratching and cleans without special product.

No mortar bed is required. The tub has a built-in leveling base molded into the bottom, so it sets on the subfloor and levels off that base. Frame the alcove to the 60 x 30 inch footprint, set the tub, shim and fasten the flange to the studs, then close in over the flange.

The tub ships as the bathing fixture only, in white. The waste and overflow assembly, the trap, and the tub filler or shower valve are all ordered separately. Match the waste and overflow to a left-hand outlet and confirm the finish against your trim package before the rough-in goes in the wall.

White is the only finish offered on the 2392202. If you are matching existing fixtures across a building, white is the one that standardizes cleanly against most toilet and lavatory lines.