B-Line Eaton auxiliary support accessories, Steel, Splice plate with 1/2"-13 hardware, Double tubing support configuration, Telco gray powder coat, 2

One splice plate with 1/2"-13 hardware, supplied as a kit under part number SB201KTG. The plate is steel with a telco gray powder coat finish, and it is set up for a double tubing support configuration. Because the 1/2"-13 bolts and nuts come with it, you are not sourcing fasteners separately to make the splice.

The telco gray powder coat is the standard indoor telecom equipment room finish, which is what this steel splice kit ships in. Powder coat over steel is a painted finish, not galvanized or stainless, so keep it in conditioned indoor runs. For exposed exterior or wash-down environments, specify a hot dip galvanized or stainless auxiliary support instead.

Yes. The SB201KTG is supplied as a single splice plate with its 1/2"-13 hardware, so order one kit for every tubing joint in the run. Count your splices off the layout, not the total length, and add kits for any field cuts you expect.

This is an auxiliary support accessory on the electrical side, and its certification record reads Not Applicable, so do not submit it as a listed or certified component. It is a mechanical splice plate, and the listed components on a cable runway system are typically the runway and grounding hardware rather than the splice plates.

1.7 lb per kit. On a long overhead cable runway that number matters when you are totaling dead load at each threaded rod or trapeze drop point, so count one kit per splice in your takeoff. The carton envelope is 8.5 x 8.5 x 1.5 inches.

The kit uses 1/2"-13 hardware, which is a 1/2 inch diameter bolt with 13 threads per inch, the UNC coarse thread. A 3/4 inch socket or wrench covers a standard hex head and nut in that size. No drilling is required at the plate itself since it comes prepped as a splice plate.