B-Line Eaton series open racks, 90.125" height, 7" length, 3.625" width, Aluminum, RCM rack mounted vertical cable manager single sided, Direct pdu m

At 90.125 inches tall, this manager runs taller than a standard 84-inch (7-foot) rack, so it is sized for taller open frame racks rather than a 7-foot frame. Check the usable height of your uprights against 90.125 inches before committing. Footprint is 3.625 inches wide by 7 inches deep.

Single sided. Model SB86283S096FB is the RCM rack mounted vertical cable manager, single sided version, so it manages cable on one face of the rack. If you need cable routed and retained on both the front and rear of the same vertical channel, you want a double-sided manager instead.

Yes. It is built for direct PDU mounting, so a vertical rack PDU attaches to the manager itself rather than eating rack units in the frame. That is the main reason to pick this version over a plain cable channel in a data or comms room build.

Cable retention is by low density plastic gate rather than a hinged solid door, with black plastic components over a flat black powder coat aluminum body. The gates let you push bundles in and out without removing hardware, which suits an open frame rack where you are adding drops over time. If you need a closed, finished look on the front, a doored manager is the better choice.

UL is the certification carried on this B-Line RCM vertical cable manager, which is normally what a facilities or institutional spec calls for on rack accessories. No other rating is claimed for it.

It is made for routing cabling on and between racks, and it includes a vertical cabling section, so it works as the vertical channel where you bring drops down and cross over to the adjacent frame in a lineup. Being 3.625 inches wide, it consumes that much aisle-to-aisle width between frames.

The channel is 3.625 inches wide by 7 inches deep and uses low density plastic gates, which puts it in the lighter duty range for cable fill. For a rack carrying a heavy fiber and copper count on both sides, step up to a wider double-sided manager; for a single-sided run of switch patching on an open frame rack, this size is the usual pick.

11.7 lb, aluminum construction, so a single tech can handle a 90.125 inch section on a ladder, though two sets of hands make aligning the full height easier.

Finish is flat black powder coat with black plastic gates and components, so it reads as black alongside standard black rack frames and other B-Line series open frame rack accessories.