B-Line Eaton series runway cable support bar, Used to support cable with vertical bend, Cable support bar, 13 gauge, Steel, Flat black powder coat

The SB16106FB is a runway cable support bar made to support cable where it makes a vertical bend, for example where cable leaves the runway and drops down to a rack or up to a ceiling. It holds the cable through the radius so the bundle is not resting on the runway edge.

Yes, the B-Line Eaton series runway cable support bar is UL Listed, which is the listing most facility and institutional specs call for on runway support accessories.

The bar measures 5.21875 in for length/depth, with a height of .5 in and a width of .5 in, and it weighs .24 lb. That half-inch by half-inch section is what you need to check against clearance between your runway stringer and adjacent hardware.

It is 13 gauge steel with a flat black powder coat, so it matches the standard flat black finish used on B-Line black runway and ladder rack rather than the gray or zinc finishes.

It is a single cable support bar, not a complete drop-out or waterfall assembly. For a run with several vertical transitions you order a bar at each bend, and any threaded hardware or runway clamps used to attach it are separate items.

Order by Eaton B-Line part number SB16106FB. The FB suffix is the flat black powder coat finish, so a bar ordered without that suffix will not match a black runway system.

No. A support bar like the SB16106FB mounts at the point where cable bends vertically off a runway and carries the bundle through that bend. A J-hook supports cable in a horizontal run between structural points, and a tray drop-out is a formed radius fitting for sheet-metal cable tray. If your cable is leaving a ladder-style runway and turning down or up, the support bar is the correct accessory.