B-Line Eaton series runway to rack support kit, Mounting plate,Used to secure cable runway to top angles of rack,Acodates runway in parallel or perpen

It is a mounting plate kit that ties cable runway down to the top angles of an equipment rack, so the runway is supported off the rack itself rather than needing separate wall or ceiling support at that point. The plate attaches through mounting holes.

Either. The SB213224FB support kit accommodates runway in parallel or perpendicular orientation to the rack, so the same kit works whether your ladder rack runs along the row or crosses over the top of the cabinet.

Yes, that is exactly what it is built for: a 6 inch upright network equipment rack top plate runway support kit. It mounts to the top angles of that upright.

UL Listed, yes. That is the stated certification on the kit, which is usually what an institutional or government spec is asking for on rack and runway support hardware.

The plate measures 24.38 in wide, 7 in in length/depth and 2.75 in high. That width spans past the 19 inch mounting rails of a standard EIA rack, which is what lets it pick up both top angles and carry runway across the top.

A36 steel with a flat black powder coat, so it matches the flat black finish used on most B-Line black runway and rack product. Structural A36 steel rather than formed light-gauge sheet.

Not necessarily. This kit exists to transfer runway support into the rack's top angles. If the runway run is fully carried by threaded rod or wall angle and you only need it to pass over the cabinet, you do not need a rack support plate. Use it where you want the rack to carry the runway or where you need the runway positively tied to the rack top.

12.9 lb for the kit. Light enough to handle from a ladder by hand, but at 24.38 in wide it is easier to set on top of the rack angles and start the mounting hardware with a second set of hands.