B-Line Eaton series strut fittings and accessories, 2" Height, 2.62" Length, 1.62" Width, .41lbs, Steel, Three hole adjustable corner angle, Stainless

It is stainless steel, type 304, not a plated carbon fitting. That matters if you are running strut outdoors, in a wash-down area, a food plant, or a coastal site where plated fittings rust at the cut edges. The base material is listed as steel with a type 304 stainless finish, so pair it with stainless strut and stainless channel nuts to avoid mixing metals in the same connection.

Order Eaton B-Line part number B371-2SS4. The SS4 suffix is the type 304 stainless version of the B371 adjustable corner angle, so if a submittal calls for plain or electro-galvanized, that is a different suffix and not this part.

The fitting measures 2 in height, 2.62 in length/depth, and 1.62 in width, and weighs .41 lb. Those numbers decide two things on a job: whether the bracket clears adjacent conduit or pipe inside a tight ceiling cavity, and how much dead load you are adding when you specify dozens of them on a long trapeze run.

No. The B371-2SS4 is the angle fitting only, so order the hardware separately. For a stainless run you want stainless channel nuts and hex bolts in the same 304 family as the fitting finish, otherwise the plated fastener becomes the first thing to corrode in an exterior or wash-down installation.

The B371-2SS4 is supplied as a plain strut fitting with no certification attached to it. If your submittal requires a listed or certified seismic bracing component, specify a fitting that is documented as such for that application rather than assuming this angle covers it.