B-Line Eaton series wall mount 9.25 inch shelf width distribution , 96" height, 86" length, 16.375" width, 2 vertical with 11 shelves, ASTM A36 struct

Plan the opening at 96 inches high, 86 inches along the wall, and 16.375 inches of projection off the wall face. That 96 inch height means a standard 8 foot ceiling leaves essentially no clearance above the frame, so check for soffits, conduit runs, and sprinkler heads before you lay it out.

The frame itself weighs 77.063 lb bare. That is before any terminal blocks, cable, or shelf load, so the real design load is the frame plus everything the 11 shelves carry. It is a steel frame, so anchor into structure or solid backing, not drywall alone.

Yes. The application for this frame is corner mounted SB658 terminal block mount plate, so the SB658 plates are the intended block mounting on it.

Two verticals carrying 11 shelves, each shelf 9.25 inches wide. It is configured as a wall mount universal distribution frame, so the verticals mount flat to the wall rather than standing free on the floor.

A wall mount frame like this one puts the verticals against the wall and keeps the floor clear, which suits a small telecom or MPOE room where you are terminating copper on block plates. Its depth off the wall is only 16.375 inches, so it will not house deep switchgear or full depth network equipment. If you need rear access or deep gear, a floor standing rack is the better call.

ASTM A36 structural steel with a Telco gray powder coat. A36 is the common structural carbon steel grade, and the Telco gray finish is the standard telecom equipment room color, so it blends with existing racks and cable rack in a frame room.

No rating is carried on this frame. Certifications are marked Not Applicable, so treat it as a structural steel mounting frame and let your inspector judge it against the room's requirements rather than a product listing.