Baldwin Estate 6501000A Mortise Wood Door Thick Door Kit

The 6501000A kit is built for doors from 1-3/4 inches up to 2-1/4 inches thick. Standard commercial and most exterior doors are 1-3/4 inches, so anything above that, a heavy entry slab or a built-up custom door, is where this kit comes in. If your door is exactly 1-3/4 inches, the mortise lock's standard spindles and screws normally handle it without a kit.

It's an add-on. The 6501000A is a thick door kit for a Baldwin Estate mortise lock, not a lock or a lever on its own. You order it alongside the mortise lock when the door is thicker than standard so the trim and lever hardware can be made up to the extra thickness. Buy it expecting to already have the Estate mortise lock, handles, and cylinder.

No. This is a mortise wood door kit, made for Baldwin Estate mortise lock installations. A cylindrical or tubular latch uses different spindles and mounting hardware, so the 6501000A parts won't adapt it. Match the kit to a mortise-prepped wood door.

Yes. Two inches falls inside the 1-3/4 to 2-1/4 inch range the 6501000A covers, so it's the part you add to make the Estate mortise lock work on that slab. Anything over 2-1/4 inches is outside what this kit handles.

Baldwin catalogs the Estate 6501000A as residential. It's intended for homes and residential entry doors rather than high-traffic commercial or institutional openings. Property managers specifying for a multi-family entry should weigh that traffic level before standardizing on it.

Only one configuration is sold: the 1-3/4 inch to 2-1/4 inch door range. There's no separate finish selection to make, since the kit supplies the internal spindle and fastener hardware rather than visible trim. Your finish decision happens on the Estate lock and lever themselves.

Brass and steel. The brass components match the Estate Series trim materials and the steel parts carry the mechanical load inside the door, which is what you want on a heavy slab where the spindle and fasteners span an extra half inch or more.