Progress Lighting PROG_P8222-A_16.01985_testlabreports Ceiling Mount PROG_P8222-A_16.01985_testlabreports

It installs directly to a 4 inch J-box with 1-1/2 inch depth, using a snap-in connection and the included mounting strap. The fixture comes prewired with a 6 inch wire lead and a copper tinned ground wire, so there is no separate driver box to find room for. Overall it is 7-1/4 inches in diameter and 1.1875 inches high, so it covers the box opening with a low profile ceiling.

It is Wet Location Listed and carries cCSAus certification, so a shower or tub location is within its listing. The housing is die-cast aluminum with a powder coat paint finish and the lens is diffused polycarbonate, which is why it holds up in damp bath areas.

Yes. It meets California Title 24 JA8-2016 and the JA8 attribute is flagged yes, which is what inspectors look for on high-efficacy residential lighting in California. Title 20 and Title 22 do not apply to it. It is also Energy Star certified.

Dimming is Triac/Forward Phase only, down to 10 percent brightness. Standard incandescent-style forward phase wall dimmers are the right match; ELV/reverse phase or 0-10V controls are not what this fixture is built for. If your units are on older Triac dimmers, that is the protocol it wants.

Output and distribution are comparable to a 100W incandescent lamp while drawing 17.3 watts at 67.6 lumens per watt. Color is 3000K with 90 CRI, so skin tones and finishes read accurately, which matters in a bathroom or bedroom. The LED board is integral and included, so there is no lamp to buy.

It is suitable for both IC and NON-IC applications, so insulation contact at the box is acceptable. Mounting is flush to the ceiling and it is not a convertible up/down fixture, so plan it as a ceiling-only close-to-ceiling install.

Each fixture draws 0.146 A at 120 V, 60 Hz, hardwired. That lets you put a large number on a single 15 A branch circuit before you hit capacity, which is the usual reason property managers standardize on a unit like this across a building. It is a 120 V only fixture, not multi-volt.

Minimum starting temperature is -30 C, and maximum operating temperature is rated at 30 C. Combined with the wet location listing, cold unconditioned spaces and covered exteriors are within its range.

Finish is painted white over die-cast aluminum, and the lens reads white as well, so it blends with white ceilings and white bath trim. It is offered in white only, with a modern/transitional look intended for bathrooms and bedrooms.

No photocell and no integral sensor. Switching and dimming are handled at the wall, which is why the Triac/Forward Phase dimmer choice is the only control decision you need to make. It is also FCC Title 47, Part 15, Class B for EMI, so it will not interfere with residential electronics.