B-Line 4D2009PASS6 Eaton series 4Dimension strut pipe clamps and fittings

The 4D2009PASS6 ships preassembled with a combination recess hex screw included, so no separate fastener is needed to attach the clamp to the strut. Plan for the strut channel itself and any nut required by your channel type; the clamp and its screw are what you get in the part.

Steel. That makes it suited to interior strut-mounted pipe and conduit runs; for corrosive or wet exterior locations most specs call for a stainless or hot-dip galvanized clamp instead, so check what your drawing requires before substituting.

The clamp measures 2.389 in on its length/depth dimension, 1.25 in wide, and .104 in high, and weighs .15 lb. Those figures matter when you are spacing multiple clamps along one length of channel or stacking parallel conduit runs, since the 1.25 in width sets the tightest practical on-center spacing between adjacent clamps.

A universal pipe clamp such as the B-Line 4Dimension 4D2009PASS6 fastens pipe or conduit directly to strut channel, and it arrives as a preassembled unit with its screw rather than as loose halves you thread together on the ladder. A two-piece strap or clevis hanger is the choice when you are suspending pipe from a rod or fastening straight to structure; the strut clamp is for runs already supported on channel.

Order by MPN 4D2009PASS6, the Eaton B-Line 4Dimension universal strut pipe clamp. It is a single configuration, so there is no finish or size option to pick, which makes it straightforward to standardize across a building where the same clamp is already installed on other runs.

The 4D2009PASS6 is supplied as a plain steel strut pipe clamp in Eaton B-Line's 4Dimension line with no rating carried on the part. If your submittal requires a specific listing or seismic bracing rating, specify a clamp whose data sheet calls that out, because this one is sold as a standard support fitting.