B-Line 1214208 Eaton series CT meter socket TS provision, 20 A, Ring type door /cover, Overhead and Underground, ANSI 61 gray painted, #14-#10 load and line lug size, Galvanized steel, Surface mount, 8 jaws, 1 position, NEMA Type

Yes. The 1214208 CT cabinet carries a Type 3R degree of protection, which is the rain-tight rating used for outdoor wall-mounted metering enclosures, and the shell is galvanized steel finished in ANSI 61 gray paint. It is a surface mount enclosure, so it bolts flat to the wall or to a strut backing rather than recessing into it.

Plan on 24.38 inches wide by 20 inches high, with 4.625 inches of depth off the wall face. It weighs 37 pounds, so on masonry or hollow block you want anchors rated for that load plus conductor weight, and two people on the set.

No, and this is the most common misread. The 20 A rating is the secondary, instrument-transformer side rating for the metering circuit, not the service capacity. Current transformers installed ahead of it carry the service load; the socket sees only the CT secondary output. The line and load lug range of #14 to #10 confirms it: those are control-wire sizes, not service conductors.

The 1214208 is an 8-jaw, single position socket, which is the transformer-rated ringed configuration most utilities specify for three-phase four-wire CT metering. Utilities publish an approved meter socket list and jaw count is the first thing they check, so match the 8-jaw, ring-type spec against your local requirement before you set it. Self-contained meters use 4, 5, or 7 jaws and will not land in this socket.

Ring type. The 1214208 uses a ring-style door and cover, so the meter is retained by a sealing ring rather than by a ringless cover that clamps over the meter flange. Utilities generally mandate one or the other, and the two are not interchangeable in the field, so if your utility specifies ringless you need a different enclosure.

It ships with a removable test switch perch rather than the switch itself. The perch is the mounting provision, so the utility or the meter tech installs the test switch of their choice onto it, and it can be pulled out if the utility does not want one. Order the test switch separately if your utility requires it in place at inspection.

The line and load lugs take #14 through #10 conductors. Standard CT secondary practice is #10 or #12 copper, so that range covers a normal install. Anything larger will not seat, and #14 is the smallest the lug will grip reliably.

Both. The 1214208 is rated for overhead and underground feed, so it works for a service drop from above or a lateral coming up from below. That saves stocking two versions across a multi-building property where some services are pole-fed and others are underground.

Yes, the 1214208 carries UL certification. On commercial and multi-family metering that listing is normally what the utility and the AHJ want to see before they release the meter.

The enclosure is galvanized steel under ANSI 61 gray paint, which is the standard outdoor utility finish and is fine for normal exterior exposure at a 3R rating. In salt air or regular wash-down, expect to touch up scratches at the knockouts and mounting holes where the coating is broken, since bare steel at those points is where corrosion starts.

Eaton B-Line part number 1214208. That single number covers the complete assembly: 8 jaw, one position, ring type, 20 A, overhead or underground feed, 3R galvanized steel enclosure in ANSI 61 gray.