B-Line Eaton series Grip Strut eight diamond plank, 240" Grating length, 36" Grating width, Steel, 5" Channel size, Plain, Grip Strut, 10 gauge

Yes. The B-Line Grip Strut eight diamond plank is listed as OSHA compliant and is intended for safe, sturdy footing where non-slip walking surface is required, which is what a facility or MRO buyer needs for elevated walkways, stair treads and equipment platforms.

Plain means bare steel with no galvanized or coated finish applied. It is fine for interior, dry, or protected locations, or where you intend to paint or coat it yourself after install. For wet, washdown, or exterior exposure, order a galvanized version of the Grip Strut plank instead, because bare 10 gauge steel will corrode.

The diamond count describes how many rows of pierced, serrated diamond openings run across the walking width. Eight diamonds gives the 36 inch width on this one. Narrower planks with fewer diamonds are used for single stair treads or catwalks under a yard wide. Pick the diamond count that matches the width you need so you are not field-cutting the plank to fit.

The manufacturer part number is 85010 20 BL P, which is the Eaton B-Line 10 gauge steel eight diamond plank, 5 inch channel, plain finish, 240 inches long. Quote that number to keep additional runs identical to what is already installed.

The 85010 20 BL P is the plank only. Support steel, hold-down clips or saddle clips, and fasteners are ordered separately, so budget those into the job along with the supporting framing that sets your span between bearing points.

Yes, steel plank of this type is routinely cut to length on site. Cutting a plain finish plank leaves bare steel at the cut, so on this 10 gauge steel plank the cut ends should be deburred and coated if the location calls for it.