B-Line Eaton series Grip Strut five diamond plank, 120" Grating length, 11.75" Grating width, Steel, 2" Channel size, Galvanized, Grip Strut, 12 gauge

Yes. The five diamond Grip Strut plank is listed as OSHA compliant and is intended for safe, sturdy footing where a non-slip surface is required, such as platforms, catwalks and stair treads around equipment.

The plank is 12 gauge steel with a mill-galvanized finish, so it holds up in damp and outdoor service like rooftop walkways, pump pads and exterior platforms. Mill-galvanized is a coating on the coil before fabrication, so cut ends are raw steel and are usually field-coated on jobs where corrosion matters. For heavy chemical exposure, a stainless or heavier hot-dip grating is the better call.

A 120 inch plank weighs 6.2 lb, so a single man can carry and set it, which is the main reason crews use plank over cast or welded bar grating on retrofit work at height. Plan your lifts and rooftop loading around that figure when you are staging a long run.

The diamond count describes how many rows of pierced, serrated diamond openings run across the width of the plank, so it sets the width. Five diamond gives the 11.75 inch wide surface here, which suits walkways and platform decking. Narrower two and three diamond planks are what you use for stair treads and single-line access runs. Channel height, 2 inches here, sets the span capability rather than the diamond count.

Order Eaton B-Line model 52012F 10 GL. That is the five diamond Grip Strut plank, 12 gauge steel, 2 inch channel, 120 inch length, 11.75 inch width, mill-galvanized.

Yes, 12 gauge steel plank is routinely cut on site with a metal-cutting saw to fit between supports. The plank ships at 120 inches, and cut ends should be touched up since the mill-galvanized coating is applied before fabrication.

What ships is the plank itself, model 52012F 10 GL. Support framing and hold-down hardware are ordered separately, so size your clips to the 2 inch channel height when you spec them.