B-Line Eaton series Grip Strut three diamond plank, 144" Grating length, 7" Grating width, Steel, 2.5" Channel size, Mill-galvanized, Grip Strut, 14 g

The Grip Strut plank runs 144 inches long and 7 inches wide, with a 2.5 inch channel size and 2.5 inch overall height. So one piece covers a 12 foot run and gives you a 7 inch walking width. For wider catwalks or platforms, planks are set side by side to build up the width you need.

Yes. The Eaton B-Line Grip Strut three diamond plank is listed as OSHA compliant, and the diamond-pierced surface is what does the work: it gives non-slip footing on walkways, catwalks, stair treads and platform decking where slip resistance is required.

Mill-galvanized steel is the standard finish here and it handles normal industrial interiors, mechanical rooms and covered exterior areas. The zinc is applied to the coil before forming, so the sheared edges and pierced diamonds are bare steel. In constant wet, washdown or coastal exposure, spec a hot-dip galvanized-after-fabrication or stainless plank instead.

14 gauge is the sheet thickness of the steel the plank is formed from. Paired with the 2.5 inch channel depth, it is the common choice for pedestrian walkways, stair treads and equipment access platforms on moderate support spacing. If your span between supports is long or you are moving carts and heavy equipment across it, step up to a heavier gauge or a deeper channel rather than stretching this one.

Yes, the steel plank can be field cut to length with a saw or torch to suit your platform layout. Cut ends expose bare steel on a mill-galvanized product, so touch them up with a cold galvanizing compound if the plank is going anywhere damp.