B-Line Eaton series Grip Strut two diamond plank, 120" Grating length, 4.75" Grating width, Steel, 2" Channel size, Mill-galvanized, Grip Strut, 12 ga

Yes, the Grip Strut two diamond plank is listed as OSHA compliant and is intended for safe, sturdy footing where a non-slip surface is required. The pierced-and-formed diamond openings are what give it the traction, and they also let water, oil and debris fall through rather than pooling on the walking surface.

Mill-galvanized steel is a pre-galvanized coating applied to the sheet before forming, which means the sheared edges and pierced diamonds are raw steel. It handles damp indoor plants, covered platforms and sheltered exterior runs. For constant weather exposure, salt spray or washdown chemicals, specify a hot-dip galvanized or stainless version of the same plank instead, where the coating covers the cut edges.

The diamond count is how many rows of pierced openings run across the width. This 22012 10 GL is a two diamond plank at 4.75 inches wide, which suits narrow catwalks, stair treads, ladder rungs and filling in between wider planks. If you are decking a full platform, a wider plank in the same 2 inch channel depth covers more ground per piece and cuts the number of fasteners at each support.

The 22012 10 GL is supplied as the plank only, one 120 inch piece. Hold-down clips, saddle washers or weld-down attachment to your supporting steel are ordered separately, and the support spacing is set by your platform design, not by the plank.

Yes. The plank is 12 gauge steel and cuts cleanly with a chop saw or bandsaw, so a 120 inch piece can be trimmed to fit a landing or stair tread. Because the finish is mill-galvanized, the cut end is bare steel, so hit it with a cold galvanizing compound if the run sees any moisture.