B-Line Eaton series Grip Strut two diamond plank, 144" Grating length, 4.75" Grating width, Steel, 3" Channel size, Mill-galvanized, Grip Strut, 10 ga

The channel is 3 inches deep, which is also the overall height of the plank. Figure 3 inches of build-up above your support member when you are checking headroom, ladder landings, or matching an existing walkway elevation.

Yes, the two diamond Grip Strut plank is listed as OSHA compliant. The serrated diamond openings are punched to give a non-slip surface, which is what it is intended for: sturdy footing anywhere slip resistance is required, such as mechanical platforms, catwalks, and equipment access walkways.

The plank is steel with a mill-galvanized finish, which is zinc coating applied to the coil before forming. That handles normal industrial and covered outdoor exposure. Because the finish is applied pre-fabrication, the cut ends and punched edges are bare steel, so in constantly wet, coastal, or chemical wash-down service you should expect edge rusting and look at a hot-dip galvanized or stainless plank instead.

It is formed from 10 gauge steel, the heaviest of the common Grip Strut gauges and the one specified where traffic is frequent or loads are concentrated. Span capacity depends on how far apart your supports are set, so lay out your support spacing to the load you are carrying rather than assuming a single rating for the plank.

No. The 24010 12 GL is the plank only. You supply the hold-down hardware, whether that is grating clips, saddle clips with bolts, or field welding to the supporting steel, and any end closure or nosing your platform detail calls for.

Yes, the 10 gauge steel plank can be cut to length on site with a metal-cutting saw or torch. Keep in mind the mill-galvanized coating does not cover a fresh cut, so touch up cut ends with a cold galvanizing compound if the walkway sees moisture.