B-Line Eaton series ground mounted panel enclosure, 72" height, 18" length, 48" width, 4X, Hinged cover, 4XFFSD enclosure, Ground mount, Large double

NEMA 4X is the rating for outdoor use against windblown dust, rain, hose-directed water and corrosion, and the fiberglass body of the Eaton B-Line 724818-4XFFSD is what earns the corrosion part of it. A seamless poured in-place gasket seals the doors, so there is no spliced gasket joint to wick water at a corner. That combination is what specifiers pick for salt air, wastewater plants, car washes and chemical areas where painted steel would blister.

72 inches high, 48 inches wide, 18 inches deep. That 18 inch depth is what decides whether a breaker panel or starter stack plus wire bending space fits, so check the depth of your deepest device before you commit. It weighs 300 lb empty, so plan rigging and a pad that can take it.

No. The 4XFFSD is supplied with no mounting provisions inside, meaning no back panel, no rails and no pre-drilled holes. Order a fiberglass or steel back panel sized for a 72 x 48 enclosure separately, along with any DIN rail or stand-off kit, or fabricate your own. Factor that into the material list before the job hits the field.

The 724818-4XFFSD carries UL 508A, which is the standard panel shops build to for industrial control panels. If your submittal calls for a 508A listed 4X enclosure for a motor control or PLC panel, this meets that on the enclosure side.

Yes. It has a padlock provision, plus a stainless pull drawn catch on the hinged doors. That is the usual arrangement for utility yards, lift stations and parking lot gear where you need the doors held tight against the gasket and secured with your own padlock. Bring your own lock, shackle sized to the hasp.

At 48 inches wide, a single door would swing nearly four feet into the work aisle. The large double door style splits that into two leaves, so you can open it in a tight yard or between equipment and still get full face access to a 72 x 48 back panel. Both leaves are hinged and seal against the same poured in-place gasket.

No holes of any kind. The 4XFFSD arrives with no mounting provisions and no factory knockouts, so all conduit entries are field cut. Cut and seal them with 4X rated hubs or fittings, otherwise you lose the NEMA 4X integrity at the penetration.

It ships unfinished in the standard grey fiberglass, not a painted enclosure. Unfinished fiberglass is what most outdoor and corrosive installs use as-is; if your spec calls for a specific color match across a facility, that is a field finish or a different enclosure line.

United States. That matters on public work where a Buy American or domestic content clause applies, and it is a line item institutional and government buyers usually have to document.