B-Line Eaton series imperial cable tray and ladder, 6" Height, 25.285" Length, 24" Width, Series 2-5 vertical outside bend, Aluminum, 60° Angle, 24" R

A vertical outside bend carries the tray run over an obstruction or down a change in elevation, with the bend turning away from the cable side. This Eaton B-Line piece turns 60 degrees on a 24 inch radius, so the cable bending radius through the fitting is held at 24 inches. Use it where the run has to drop or rise over ductwork, beams, or a wall penetration rather than turn horizontally.

Yes, provided the run is Eaton B-Line Series 2 through 5 aluminum tray. The fitting is built at 24 inches wide and 6 inches high, in aluminum, so it mates load-side to load-side with a matching 24 inch wide, 6 inch deep aluminum straight section. If your straight tray is a different width or a different rail depth, this fitting will not line up at the splice.

Allow 25.285 inches of run length for the fitting, measured along the depth of the piece, plus clearance for the 24 inch radius sweep as it turns 60 degrees. Lay it out before you cut your straight sections, because the bend consumes more run than a mitered fitting would.

Aluminum is the usual pick where corrosion or weight matters. This Series 2-5 outside bend is aluminum and weighs 9.6 pounds, light enough for one person to set and hold while the splice plates go on, which matters on overhead work at height. Steel tray carries more load per span but adds weight and needs a coating in wet or chemical environments.

The Eaton B-Line part number is 6A-24-60VO24. Read it as 6 inch rail height, 24 inch width, 60 degree vertical outside bend, 24 inch radius.

The 6A-24-60VO24 is the bend section itself. Splice plates, hardware, and any supports or hangers for the fitting are ordered separately, so count the connections at each end of the bend when you build the material list.

It carries the CE mark. That is the only marking recorded for this Series 2-5 vertical outside bend, so if your spec calls for a specific listing beyond CE, verify against the submittal for the full tray system.