B-Line Eaton series imperial cable tray and ladder, 6" Height, 27.9375" Length, 6" Width, Series 2-5 horizontal bend, Aluminum, 60° Angle, 24" Radius

It's a 60 degree horizontal bend for Eaton B-Line imperial ladder cable tray, used to turn a run 60 degrees in the flat plane. It's built on a 24 inch inside radius, so it swings the cable around the corner gradually rather than at a sharp break. Aluminum construction, 6 inch loading depth, 6 inch tray width.

A horizontal bend turns the run left or right while the tray stays flat, which is what the 6A-06-60HB24 does at 60 degrees. If the run has to rise or drop (over a beam, down a wall), that's a vertical inside or outside elbow instead, and it is a different fitting entirely. Pick by the plane of the turn, not the angle.

Order connecting hardware separately. The 6A-06-60HB24 is the bend section itself at 7.7 lb; splice plates, bolts, and any supports or hangers for the corner are separate line items. Budget for a splice connection at each end of the fitting where it meets the straight sections.

Specify Eaton B-Line 6A-06-60HB24: imperial ladder tray, aluminum, 6 inch width, 6 inch height, 60 degree horizontal bend on a 24 inch radius. It carries a CE mark, which is worth noting on export or European-spec projects.

Aluminum is the usual pick for outdoor, wash-down, and coastal work because it resists corrosion without a coating, and it is light (this fitting is 7.7 lb) so supports carry less dead load. Where you need higher strength or a specific fire-resistance or grounding scheme, steel tray is the alternative. Stay consistent with the material of the straight sections in the run.