B-Line Eaton series imperial cable tray and ladder, 6" Height, 45.188" Length, 9" Width, Series 2-5 vertical inside bend, Aluminum, 90° Angle, 36" Rad

A vertical inside bend turns the tray run upward or downward through 90 degrees with the fitting's curve on the inside of the turn, so the cables stay supported around the change in elevation instead of bending over a cut edge. The Eaton B-Line 6A-09-90VI36 is the 36 inch radius version, which gives cable a long, gentle sweep around the turn rather than a tight one. Use an outside bend where the geometry of the turn puts the tray's rungs on the outside of the curve instead.

Aluminum. That keeps the fitting light (17.9 lb) and suits damp, corrosive or coastal environments better than plain painted steel, but aluminum tray is a different metal from steel tray, so do not mix the two in one bonded run without addressing the dissimilar-metal connection. The fitting is UL Classified.

Yes, it carries a UL Classified marking. For a cable tray fitting that is what most electrical inspectors and spec writers are looking for on the submittal, alongside the material and the tray series.

Order Eaton B-Line 6A-09-90VI36. Reading the code: 6 inch depth, aluminum, 09 for 9 inch width, 90 degree vertical inside bend, 36 inch radius. Splice plates and hardware are ordered separately from the fitting itself.

It weighs 17.9 lb, so it is a one-man lift in most situations. The awkward part is the 45.188 inch overall length on a 36 inch radius sweep, which is bulkier than it is heavy when you are positioning it overhead.