B-Line SB86083D090SL Eaton series open frame racks, 84.875" height, 21.625" length, 3.625" width, Aluminum, RCM rack mounted vertical cable manager double sided, Direct pdu mounting, Low density plastic gate, Silver powder coat

At 84.875 inches tall, the SB86083D090SL runs the full height of a 7-foot (84 inch) open frame rack, so plan on it standing slightly above the rack rails. Footprint is 3.625 inches wide by 21.625 inches deep, so you need a clear 3-5/8 inch channel beside the rack uprights and about 21-5/8 inches of aisle depth for the manager body.

Double sided. The SB86083D090SL has gates on both the front and the rear, giving you double the cable capacity of a single-sided channel, so you can route switch patching on the front face and power or uplinks on the back without mixing bundles in one channel.

Yes, it's built for direct PDU mounting, so a vertical rack PDU fastens into the manager channel itself rather than eating rack units or hanging off the rack rail. That is the reason to choose this version over a plain cable channel when you have zero-U power strips to place.

It uses low density plastic gates in black. Low density refers to the fill it's set up for, so it suits moderate cable counts, patch and power runs on a typical two-post or four-post open frame, rather than a fully loaded high-count fiber and copper build where you'd want a higher capacity channel. The gates swing to let you drop cable in from the side instead of threading it end to end.

Push-in fasteners and a cable strap mount ship with the manager, so you have the pieces to secure the channel and anchor cable straps. What is not included is any rack mounting hardware for gear, or the PDU itself, those come with their own equipment.

UL is the certification carried on the SB86083D090SL, which is normally what a facilities or institutional spec calls for on rack and cable management infrastructure. If your drawing calls out a specific UL standard number, match it against the manufacturer label before submitting.

Order it as Eaton B-Line SB86083D090SL. That number carries the whole configuration: 84.875 inch height, 3.625 inch width, 21.625 inch depth, double-sided low density plastic gates, direct PDU mounting and silver powder coat. Change any one of those attributes and it is a different part number in the B-Line series.

The body is aluminum with a silver powder coat, and the gate components are black plastic. If your existing open frame racks are silver or clear anodized, this matches visually; if the room is standardized on black racks, this one will stand out.