B-Line SB862812D096EW Eaton series open frame racks, 90.125" height, 3.25" length, 2.625" width, Aluminum, RCM rack mounted vertical cable manager double sided, Direct pdu mounting, Low density plastic gate, White, Double sided vertical cable manager

The B-Line SB862812D096EW measures 90.125 inches tall, which lines up with a standard 45U seven-foot open frame rack (84 inches of rail plus base and top). Check your rack's overall frame height rather than its U count before ordering, since the manager runs the full height of the upright and needs the clear vertical run to mount.

No. The RCM double sided manager is specified for routing lower density cabling, and at 2.625 inches wide with a low density plastic gate it will not carry the bundle volume of a fully loaded high-density patch field. For heavy Cat6A or fiber counts, step up to a wider, deeper vertical manager with high-capacity doors and full-height finger sections.

Yes. Direct PDU mounting is built into the SB862812D096EW, so a vertical rack PDU can be fastened inside the channel instead of taking up a rail or a separate mounting bracket. That keeps the power strip and the cable run in the same vertical space.

It's a slim channel: 2.625 inches wide and 3.25 inches deep. That footprint is meant for a narrow gap between bayed racks or the outside face of an upright, so it won't eat much aisle width, but it also means cable capacity is limited to lower density runs.

Double sided means the channel manages cable on both the front and rear faces of the upright, so you can keep patch cords on one side and switch or server cabling on the other without them crossing. Front and rear are both gated by the plastic gate, and vertical cabling sections are included.

UL is the certification carried on the SB862812D096EW. That's the listing to cite if your spec or facility standard calls for UL cable management components in the rack room.

Order Eaton B-Line part number SB862812D096EW. That is the 90.125 inch, white, double sided RCM rack mounted vertical cable manager with the low density plastic gate and direct PDU mounting.

The finish is Eaton white powder coat over aluminum, with plastic gate components in white, so it matches other Eaton B-Line white powder coat rack hardware. If your existing frames are black, order the black version instead rather than mixing finishes down a row.

Aluminum is the body material here, with plastic gate components. For a vertical channel that carries cable weight and a mounted PDU rather than equipment load, aluminum is appropriate and keeps the 90-inch section down to 26.4 lb. Structural load in the rack is carried by the frame uprights, not the manager.