B-Line Eaton series panels and panel accessories, White powder coated, Used with type 1 and type 3R telephone cabinets, Wood, Wood back board, Panels

Yes. The 1010 WB is sized 10 x 10 x 10 inches as listed and is made to drop into Eaton B-Line type 1 and type 3R telephone cabinets of that nominal size. It is the wood mounting panel that goes inside the enclosure, not the enclosure itself, so you order it to match the cabinet you already have.

The 1010 WB is rated for use in both type 1 (indoor) and type 3R (rain tight, outdoor) telephone cabinets. The wood is white powder coated, which is what lets it live in a 3R enclosure exposed to weather rather than a dry indoor-only box.

Yes, the 1010 WB carries a UL Listing. For an inspector looking at a telecom or low voltage enclosure, that is the panel-level listing on the back board itself; the cabinet it mounts in carries its own type 1 or 3R rating.

Wood is the usual choice where you are screwing in terminal blocks, 66 blocks, patch gear or small power supplies and want to fasten anywhere on the face without drilling and tapping steel. It is also non-conductive. The 1010 WB is a wood panel with a white powder coated finish. If your install calls for grounded, bonded mounting or heavy equipment loads, a steel sub-panel is the better pick.

The 1010 WB is the wood back board on its own, ordered under part number 1010 WB. The telephone cabinet is a separate purchase, and the panel mounts to the studs or standoffs already provided inside that enclosure.

Three quarters of a pound. A single tech can hold the 1010 WB in place with one hand while starting the mounting screws, which matters on ladder work at a wall mounted 3R cabinet.