B-Line B230YZN Eaton series strut fittings and accessories, 2.06" Height, 1.87" Length, 1.62" Width, .37lbs, Steel, Two hole corner angle, 90 deg | Pre assembled, Yellow zinc chromate

The B230YZN is a two hole 90 degree corner angle for Eaton B-Line strut. It ties two pieces of channel together at a right angle, one bolt into each leg, so you can turn a corner or brace a run without fabricating anything. It ships pre assembled, so the fitting comes as one piece ready to bolt up.

No. The B230YZN is supplied as the pre assembled two hole angle only. You will need to order channel nuts and hex bolts separately, sized to the strut you are connecting, plus washers if your spec calls for them.

It is steel with a yellow zinc chromate finish. That plating gives moderate corrosion resistance for indoor, dry to lightly damp locations such as mechanical rooms, ceiling spaces and plant interiors. For wet exterior, washdown or coastal work, specify a hot dip galvanized or stainless equivalent instead.

Use the 90 degree angle, like the B230YZN, when the two channels meet at a right angle, either turning a corner or kneeing a brace off a vertical post. A flat plate or splice fitting is for joining two pieces running in the same plane, end to end or lapped. With only two holes, one per leg, this angle is a connection and light bracing fitting rather than a heavy moment joint; for that, step up to a larger multi hole gusset angle.

Order it as Eaton B-Line B230YZN. The YZN suffix is the yellow zinc chromate finish, so if a drawing calls for the same fitting in another plating the base number stays B230 with a different finish suffix.

The B230YZN angle carries no certification on record. It is a mechanical steel strut fitting, so approvals on a job normally sit with the strut system and the overall support design rather than the individual angle. If your submittal needs a listing, have the engineer approve the support assembly.