B-Line Eaton series strut fittings and accessories, 2.37" Height, 3.25" Length, 1.62" Width, .63lbs, Steel, Two hole open angle, 52-1/2 deg, Thickness

No. The B151GRN ships as the angle bracket alone. You will need to add channel nuts and hardware sized to your strut for each of the two holes, plus the strut itself. Order the fasteners on the same line item so the crew is not short at install.

DURA GREEN is Eaton B-Line's coated finish, and it is the reason to pick the GRN suffix over a plain or electro-galvanized fitting. Buyers specify it where a bare steel fitting would start showing corrosion, such as damp mechanical rooms, wash-down areas, or partially exposed runs. If your run is plain indoor dry conduit support, the finish is optional; if there is moisture, it is the one to standardize on across the job so everything matches.

Order Eaton B-Line B151GRN. The B151 is the two hole 52-1/2 degree open angle in 1/4 inch steel, and the GRN suffix is the DURA GREEN finish. If a submittal lists B151 without a suffix, confirm which finish was approved before releasing the order.

It is a two hole fitting, meaning one hole per leg. A single bolt per leg lets the fitting seat flat against the channel face but does not by itself resist rotation, so on runs carrying real load, plan your bracing so the angle works in line rather than relying on one bolt to hold rotation.

The B151GRN is catalogued with certifications marked Not Applicable. Treat it as a plain steel structural fitting: if your spec calls for a listed or labeled support component, confirm with the engineer of record that an unlisted fitting is acceptable for that part of the system.