B-Line Eaton series strut fittings and accessories, 3.31" Height, 4.37" Length, 1.62" Width, .546lbs, Steel, Two hole open angle, 7-1/2 deg, Thickness

It's a two hole open angle fitting for strut channel systems, bent at 7-1/2 degrees so you can join strut at a slight off-square angle rather than a clean 90. Two bolt holes, one leg to each member. Steel, 7/32 inch thick material, and it weighs .546 lb.

It measures 3.31 x 4.37 x 1.62 inches (height, length/depth, width as cataloged), out of 7/32 inch steel. The 1.62 inch width is the figure that matters most on the job, since it's sized to sit on standard 1-5/8 inch strut face. Check your clearance against the 4.37 inch leg before you commit in a tight bay.

No. The B165GRN is the angle bracket only. You order channel nuts and hex head bolts separately, sized to the strut you're fastening to, plus any washers your spec calls for. Budget two sets per fitting, one for each hole.

DURA GREEN is Eaton B-Line's coated finish, applied over the steel body. It's the finish to specify when a plain electro-plated fitting isn't holding up, such as damp mechanical rooms, parking structures, or wash-down areas. The same fitting is cataloged in other finishes, so if you're matching existing strut runs in a building, check what's already up there before mixing finishes.

It's built for 1-5/8 inch strut, which is the common channel width across the major brands, and the 1.62 inch fitting width reflects that. Fastening is through standard channel nuts, so the practical check is the nut and bolt, not the bracket. Where slot profiles differ between brands, match the channel nut to the channel you actually have.

Order by the Eaton B-Line part number B165GRN. The GRN suffix is the DURA GREEN finish, so quoting the full number keeps you from receiving the plain or electrogalvanized version of the same bracket.