B-Line B132YZN Eaton series strut fittings and accessories, 5.37" Height, 5.37" Length, 1.62" Width, 1.00lbs, Steel, Flat five hole cross plate | Pre assembled, Thickness 1/4 in, Yellow zinc chromate

The B132YZN is a flat five hole cross plate for joining strut channel at intersections. The five holes sit in a cross pattern, so it ties two runs of channel together across a crossing point or braces a right angle joint flat against the channel face. It ships pre assembled, so it is ready to bolt up with channel nuts and hardware.

Yellow zinc chromate is a plated finish intended for dry indoor service. It gives corrosion protection in conditioned interior spaces, mechanical rooms and above ceilings, but it is not a hot dip galvanized or stainless finish. For exterior runs, wash down areas or corrosive process environments, specify a galvanized or stainless strut fitting instead.

Quarter inch steel. That 1/4 in gauge is what lets the plate carry load at a strut intersection rather than flexing like a light sheet metal brace, and it is the dimension to match if your drawing calls out a specific plate thickness.

The plate measures 5.37 x 5.37 x 1.62 inches and weighs 1 lb. The 5.37 inch square footprint is what you need clearance for on both legs of the cross; check that against the channel run and any adjacent conduit before you lay it out.

The B132YZN is supplied as a pre assembled flat plate fitting. Plan on ordering the channel nuts, hex bolts and washers separately to suit your strut size and the number of connection points you are making.

Order it as B-Line B132YZN. The B132 is the five hole flat cross plate and the YZN suffix designates the yellow zinc chromate plating, so the finish is built into the part number rather than ordered as a separate option.