B-Line Eaton series Type 1 junction boxes, 10" height, 4" length, 8" width, 1, Hinged cover, HC enclosure, Surface mounted, Small single door, 5 top-

No. The 1084 HC is a NEMA Type 1 enclosure, which is for indoor use only and protects against dust and incidental contact. It has no gasket rating for rain, hose-down, or oil. For an outdoor or wet location you need a Type 3R, 4, or 4X box instead. It is UL 50 listed as an enclosure for electrical equipment.

It measures 10 inches high, 8 inches wide, and 4 inches deep. That 4 inch depth is the number to check first if you are stacking terminal blocks, a small relay, or wire nuts behind the door, since the hinged cover swings clear but does not add interior room.

Knockouts are provided: 5 on the top, 5 on the bottom, and 5 on the sides. That lets you bring conduit in from either end or from the side without drilling or punching the carbon steel shell on the job.

Surface mounting through holes in the back of the enclosure. You supply the anchors or screws suited to your substrate (masonry anchors, toggle bolts for drywall, or self-tappers into strut or steel). At 5.5 pounds empty it is light enough for two-person handling on a ladder and does not need a backboard, though a plywood backer is common practice on block walls.

The hinged cover on the HC enclosure stays attached when you open it, so nothing gets dropped or lost in a ceiling or behind equipment, and you get one-hand access for routine testing. It is also removable, and has a recessed pull ring plus a friction dimple to hold it shut. If you want the cover positively fastened against casual opening, a screw cover box is the better choice.

The body is 16 gauge carbon steel, which is the usual commercial weight for a wall-mounted pull or junction box of this size. It holds shape when you tighten conduit connectors into the knockouts and takes a self-tapping ground screw without flexing.

Country of origin is listed as US for the 1084 HC, which is what procurement usually wants documented on federal, school, and municipal work. Order it by part number 1084 HC.

It is painted ANSI 61 grey, the standard light grey used across most industrial control and pull box lines, so it reads as a match next to typical panel and enclosure finishes. Field touch-up paint in ANSI 61 is widely available if a knockout or mounting hole scars the finish.

Single door, in the small single-door style, with one hinged cover over the full 10 by 8 inch face. For larger openings needing split access you would step up to a two-door enclosure.