B-Line Eaton series Type 3/3R junction boxes, 24" height, 10" length, 24" width, 3R, Screw cover, RTSC NK enclosure, Surface mounted, Medium single d

Yes. The Eaton B-Line 242410 RTSC NK enclosure carries a NEMA 3R rating, so it is built for outdoor use against falling rain, sleet and external ice formation. It ships with a rain hood over the door and plated screws on the cover. NEMA 3R does not cover washdown, hosedown or dust-tight service, so for a pressure-wash or heavy dust area you want a Type 4 or 12 enclosure instead.

It measures 24 inches high, 24 inches wide and 10 inches deep. The 10 inch depth is what gives you room to land conduit and bend larger conductors behind the door, so check your wall clearance and any adjacent equipment before laying out the surface mount pattern.

No knockouts. The 242410 RTSC NK is the NK (no knockout) version, so every conduit entry gets punched in the field to suit your run. That is the usual choice on a 3R outdoor box, since you control where the penetrations land and can keep them on the bottom or sides where water will not sit. Plan on a knockout punch set and weatherproof hubs or sealing locknuts at each entry.

Surface mounting through embossed thru holes formed into the back of the enclosure. The embossed holes keep the fastener path sealed off from the box interior, which is what preserves the 3R rating when you bolt it up. At 49.4 lb empty, mount to structure or solid blocking, not to unbacked drywall or thin sheet.

It is a screw cover with a flanged closure, fastened with plated screws around the perimeter. You back the screws out to get full open access to the box, which suits a junction or pull box that stays closed most of its life. If you need to open it daily, a hinged and latched door enclosure is the better pick.

The body is 14 gauge carbon steel with a painted finish in ANSI 61 grey. Carbon steel painted is the standard outdoor spec for utility, plant and rooftop work, and the 14 gauge wall gives it enough rigidity to carry conduit loads on the sides. In coastal, chemical or wash-down environments, a stainless or non-metallic enclosure is the longer-lived choice.

Yes, the 242410 RTSC NK is built to UL 50, the standard covering enclosures for electrical equipment, and it is made in the US. That plus the NEMA 3R rating is normally what a submittal for an outdoor junction or pull box needs to show.

Order Eaton B-Line part 242410 RTSC NK. The number reads as the size, 24 high by 24 wide by 10 deep, followed by the RTSC screw cover style and NK for no knockouts. It is a medium single door enclosure.

ANSI 61 grey is the standard light grey used across most switchgear, panelboards and control enclosures, so the 242410 box will read the same as the rest of a typical lineup. It arrives painted from the factory, ready to hang without field finishing.