B-Line Eaton series wall mounted panel enclosure, 48" height, 8" length, 36" width, 4X, Hinged cover, 4XSS63PT enclosure, Wall mount, Medium single d

It carries a NEMA 4X rating, and the body is 316 stainless steel with a seamless poured in-place gasket. That combination is what you want for hose-down food and beverage areas, coastal or chemical exposure, and outdoor wall mounting. 316 is the marine grade, so it holds up better against chlorides than 304.

Outside dimensions are 48 inches high, 36 inches wide and 8 inches deep. The 8 inch depth is the limiting number for most builds, so check your deepest device (breaker, VFD, disconnect shaft) plus wire bending space before you commit. If you need more room behind the panel, step up to a deeper box rather than trying to make 8 inches work.

The single door uses a 3-point latching handle, which pulls the door tight at top, middle and bottom for even gasket compression on a 48 inch tall door. Locking provision is a key lock with padlock provision, so you can padlock it for lockout or key it for restricted access.

The 4XSS63PT is UL 508A certified, which is the standard for industrial control panel enclosures. If your spec or AHJ calls for a 508A shop-built control panel, this box satisfies the enclosure side of that requirement.

It is a wall mount box with external mounting feet, so it stands off the wall surface rather than sitting flat against it. That gap is deliberate on a 4X stainless box, it lets moisture drain behind the enclosure instead of sitting between the back and the wall. Feet being external also means you drill and bolt without breaking the enclosure seal.

118.6 lb empty. That is a two-person lift at minimum, and with a 48 inch tall body you will want the mounting anchors set and rated before you hang it. Add panel, devices and wire on top of that figure when you size your fasteners or wall backing.

Yes, provided every penetration uses a 4X-rated hub or fitting and is made in the side or bottom, not the top. The enclosure earns its 4X rating from the 316 stainless body and the seamless poured in-place gasket at the door; an unsealed hole anywhere in the body voids that rating regardless of how good the door seal is.

The exterior is a #4 brushed stainless finish, the standard directional satin grain used across industrial stainless enclosures. If your existing boxes are #4 brushed 316 or 304, this will read as a match on the wall.

Country of origin is the US, which matters if you are procuring against a domestic-preference clause on a government, utility or institutional job.