B-Line Eaton series wireway, 10" height, 24" length, 10" width, G wireway, Thru holes, 7 top knockouts, 7 bottom knockouts, Screw cover, 1, Steel, Pl

It's a 10 inch by 10 inch cross section, 24 inches long, so you have 100 square inches of gross interior area to work from before derating for the 20 percent fill limit wireways are normally held to. That's a large-capacity trough, typical of gutter runs feeding multiple panels or motor control rather than a short jumper between two boxes.

No. It's a NEMA 1 enclosure, which means general purpose indoor use only, protecting against incidental contact and falling dirt. It is not raintight and should not be used outdoors, in washdown areas, or anywhere water can enter. For an exterior or damp run you need a NEMA 3R raintight wireway instead.

It's a screw cover, secured with plated screws along the length. You back the screws out and lift the cover off, which opens the full face of the trough so conductors lay in rather than being pulled through. Faster to work in than a hinged or flanged design on a first install, but slower if you expect to open it repeatedly for changes, where a hinged-cover wireway is the better pick.

Seven knockouts on the top and seven on the bottom, giving you conduit entry from either face without drilling. The ends are open thru-hole style construction for coupling section to section. If your feeds come in from the side rather than top or bottom, you'll be punching your own holes.

It's CSA Certified, which covers the Canadian and, in most inspection contexts, cross-accepted North American requirement for a listed wireway. That's the certification carried on the 101024 G; specifiers asking for a certified NEMA 1 steel wireway can reference it directly.

Yes, and it's a common use. With 10 x 10 inch internal dimensions and open thru-hole ends, a 24 inch section works as a gutter or pull section above a panel, with conduits landing in the seven top or seven bottom knockouts. Bend radius and pull-box sizing rules still govern the conductor size you can run through it, and it stays indoor-only because of the NEMA 1 rating.

14 gauge steel, painted ANSI 61 gray, with plated screws on the cover. The 14 gauge body is the heavier end of what you see in wireway and is why a 10 x 10 section holds its shape over a long horizontal run. ANSI 61 gray is the standard switchgear and panelboard gray, so it matches most electrical rooms without repainting.

The manufacturer part number is 101024 G. The number reads directly off the dimensions: 10 inch height, 10 inch width, 24 inch length, G series screw-cover wireway. Useful to know when you're building out a run, since sibling lengths in the series follow the same convention.