Bussmann TB200HB-05SS Eaton TB200HB series panel mount terminal block connector, Breakdown voltage 4800V, 600V, 30A, High barrier, Six-pole, Black, Molded thermoplastic base, tin-plated brass terminal, stainless steel SEMS philslot

Six poles, so you can terminate six separate circuits on one strip. It is a panel mount, high barrier design in the Eaton Bussmann TB200HB series, with insulating barriers between each pole to keep adjacent terminations separated.

Plan on a footprint of 8.75 x 2 x 1.25 inches for the block itself, plus clearance for wire bends and screwdriver access at the terminals. The block weighs about .02 lb, so it puts no meaningful load on the panel it mounts to.

No. The TB200HB-05SS is a panel mount terminal block connector, a six-pole strip for landing and distributing conductors inside an enclosure. It has no breakers, bus, or main lugs. If you need an actual distribution panel, look at something like the ABB ReliaGear Pro-Stock 42-circuit panelboard or the ABB MeterMod III 400A three-phase main lug panelboard instead.

No. The Bussmann TB200HB-05SS is a six-pole panel mount terminal block connector on a molded thermoplastic base with tin-plated brass terminals and stainless steel SEMS philslot screws, measuring 8.75 by 2 by 1.25 inches and weighing about .02 lb. It is a termination strip that lands and separates conductors behind a panel. The ABB ReliaGear Pro-Stock unit is a 42-circuit, 240V three-phase panelboard with a copper bus, meaning it is the distribution enclosure itself with branch breaker spaces. A terminal block does not distribute or protect circuits, so the two are not interchangeable; a TB200HB terminal block would be mounted inside a panel like the ABB, not instead of it.

The base is molded thermoplastic, the terminals are tin-plated brass, and the hardware is stainless steel SEMS philslot screws (captive washer, Phillips/slotted combination head, so it drives with either bit).

Yes, the TB200HB-05SS is CE Marked. For any other agency listings on this part, the manufacturer is the source to confirm with.

Order Bussmann TB200HB-05SS. That is the genuine Eaton Bussmann part number for the black, high barrier, six-pole panel mount block, and it is the only configuration sold under that number.

The Bussmann TB200HB-05SS is a high barrier six-pole terminal block connector rated 600V, 30A per pole, sized 8.75 by 2 by 1.25 inches - it terminates and isolates conductors, it does not serve as a service distribution point. For a 400A three-phase main lug distribution assembly, look to the ABB MeterMod III 400A three-phase main lug panelboard instead. Keep the TB200HB in mind only for the control or auxiliary wiring terminations inside that assembly, where its high barriers separate adjacent poles.

That is what the high barrier construction is for. Raised molded barriers between each of the six poles extend the surface path between adjacent terminations, which matters when you have dissimilar circuits landed side by side on the same strip. The stated breakdown voltage for the TB200HB series block is 4800V.

The Bussmann TB200HB-05SS terminal block connector is CE marked, so it carries the European conformity marking alongside its 600V, 30A six-pole high barrier construction. The ABB MeterMod III 400A three-phase main lug panelboard and the ABB ReliaGear Pro-Stock 42-circuit panelboard are North American distribution assemblies built around 240V three-phase and copper bus construction. If the CE mark is what the specification calls out for the termination hardware, the TB200HB-05SS carries it.