F4P Adhesive Cable Tie Mounting Pad - ¾" & 1", Black & White (per 100)

F4P adhesive mounting pads come in 3/4 inch and 1 inch pad sizes. The larger 1 inch pad puts more adhesive footprint on the surface, which is what you want for heavier wire bundles or runs that get bumped; the 3/4 inch is the tighter option where you are working in a crowded panel, along a narrow raceway edge, or on a trim piece with limited flat surface. Both are sold in each color and both use the same four-way tie entry.

Adhesive only. The F4P pads mount with a rubber-based adhesive back, so there is no drilling and no fastener to order. That makes them the right call on finished drywall, metal enclosures, cabinetry, and inside vehicles or fixtures where you cannot put a screw through the surface. If the job spec calls for a mechanically fastened base, you need a screw-mount tie base instead.

Four-way entry means the pad has tie slots on all four sides, so the cable tie can be run through in either axis. On a wire pull that changes direction, you set the pad once and orient the tie to follow the run rather than trying to twist the base to match. It also lets you cross two ties through the same pad when you are anchoring a bundle at a junction.

Both black and white are offered, in each of the 3/4 inch and 1 inch sizes. Property managers and low-voltage installers generally take white for exposed runs on painted walls, ceilings, and trim where the anchor should disappear, and black for panel interiors, equipment bays, and anywhere UV or grime would show on a light pad.

No. The pads are the anchor base only, so you order cable ties separately and size them to the bundle diameter you are dressing. Check that the tie width you already stock will pass through the pad slot before you standardize on a size.

They are sold by the hundred, one size and one color per pack. For an MRO stockroom or a contractor's van, that means picking the combination you actually run day to day rather than a mixed assortment, so most buyers stock white 3/4 inch for finish work and black 1 inch for panel and equipment work.