GENERAC 7229 Honeywell 14kW Home Backup Generator WiFi-Enabled

No transfer switch is included with the 7229. A standby generator can't start and pick up the house or building load on its own, so you'll need to order an automatic transfer switch sized to the service separately, along with the wiring between the gen set, the switch and the panel. Budget for that in the job before you quote it.

The 7229 is a 14,000 watt standby unit at 120/240 volts, single phase split, which is the standard residential and light commercial service configuration. That covers a whole small home or the critical loads on a larger one. If your building runs 208V three phase, this isn't the unit.

Plan the pad around 48 inches by 25 inches by 29 inches and a unit weight of 420 lbs, 419 lbs as assembled. That weight means a poured pad or a composite gen pad rated for it, and two people plus equipment to set it. Local setback from the structure and from openings still governs where on the pad it lands.

Yes. The 7229 is UL Listed, CSA Certified and ETL Listed, which is what an inspector or an institutional spec will be looking for on a permanently installed standby unit.

14,000 watts at 120/240V typically covers essential circuits plus one central air system on a normal sized home, or the critical panel in a small commercial space. If you're carrying two AC compressors, an electric range and an electric water heater simultaneously, you're past it and should size up or use a load management module to shed non essential circuits. The transfer switch you pair it with is where that load shedding decision gets made.

The enclosure frame is aluminum, finished in gray. Aluminum is what you want on a permanently installed outdoor gen set, particularly coastal or high humidity sites, since it won't corrode through the way a steel housing can.

The 7229 uses PrecisionPower technology holding total harmonic distortion under 5 percent. That's clean enough for computers, medical equipment, variable speed HVAC and modern appliance boards. Cheap open frame portables commonly run well above that, which is what puts electronics at risk on generator power.

Wi-Fi is built into the 7229, and it reports status through Mobile Link on a phone, tablet or PC from anywhere. For a property manager with units spread across a portfolio, that means you see a failed weekly self test or an alarm without a site visit.

Country of origin on the 7229 is the United States. Generac states these are engineered and assembled in the USA using domestic and foreign parts, so it meets an assembled in USA requirement but is not an all domestic content part. Check which standard your procurement spec actually cites before you commit.

An 816 cc Generac G-Force engine, pressure lubricated and purpose built for generator duty rather than adapted from a lawn equipment engine. Pressure lubrication is the part that matters for a unit that may run for days during an outage, and it's why the routine maintenance interval is lighter than a splash lubricated engine.

The 7229 runs its self test in WhisperCheck mode, a five minute exercise at reduced RPM rather than full speed. It's quieter than a full speed exercise cycle and burns less fuel doing it, which matters on a tight lot line or in a multi family setting where neighbors notice.