Midwest Fasteners Brass Plated Steel Phillips Flat Head Tapping Screw

Midwest Fasteners Brass Plated Steel Phillips Flat Head Tapping Screw

Midwest Fasteners Brass Plated Steel Phillips Flat Head Tapping Screws are self-tapping fasteners built for sheet metal, trim and decorative hardware applications where a bright gold finish matters as much as a secure grip. This family is available in sizes ranging from #6 x 1/2" up through #12 x 1", including #10 x 1", #10 x 1-1/2", #10 x 2", #10 x 3/4", #12 x 1", #12 x 3/4", #6 x 1/2", #6 x 3/4", #8 x 1/2", #8 x 3/4", #8 x 1", #8 x 1-1/4", and #8 x 1-1/2", letting installers match the exact gauge and length needed for the job while keeping the same Phillips drive, flat head, steel body and brass plated finish across every size. Manufactured in the United States, these screws self-tap into thin-gauge sheet metal without a pre-drilled, pre-threaded hole, leaving a clean, flush finish on cabinet hardware, nameplates, trim panels and light-duty metal assemblies.

Key Features

• Size Range: Available in gauges #6, #8, #10 and #12 with lengths from 1/2" up to 2", spanning #6 x 1/2" through #12 x 1".
• Product Type: Tapping screw (sheet metal screw) that cuts its own thread into thin-gauge sheet metal and similar materials without a pre-threaded hole.
• Material & Finish: Steel body with a brass plated finish for a decorative gold appearance and added corrosion resistance over bare steel.
• Head Type: Flat head seats flush with the work surface for a clean, low-profile finish on visible panels and trim.
• Drive Type: Phillips drive accepts standard Phillips screwdrivers and bits for fast, repeatable installation across every size in the range.
• Color: Gold finish complements brass and plated hardware, fixtures and decorative trim applications.
• Country of Origin: Manufactured in the United States.

Technical Specifications

• Product Type: Tapping Screw
• Product Material: Steel
• Finish: Brass Plated
• Drive Type: Phillips
• Head Type: Flat
• Product Color: Gold
• Country of Origin: United States
• Wire Size: #6 - #12

Typical Applications

• Fastening sheet metal panels, brackets and light-gauge metal components
• Attaching decorative hardware, nameplates and trim where a gold-toned screw head is desired
• Cabinet and furniture hardware assembly requiring a flush flat head finish
• General metal fabrication and repair tasks calling for a self-tapping Phillips drive screw
• Light-duty HVAC and electrical cover plate or enclosure assembly where brass plating is specified for appearance

Why Midwest Fasteners?

Midwest Fasteners builds this entire size range from steel for consistent strength, then applies a brass plated finish for a uniform gold appearance across every piece, so installers get dependable sizing, drive fit and finish from box to box regardless of which length or gauge is selected. Manufactured in the United States, these Phillips flat head tapping screws suit both decorative hardware work and everyday sheet metal fastening on the shop floor or jobsite. Stock a supply across the #6 x 1/2" to #12 x 1" range for repair, fabrication and assembly work where a flush Phillips drive fastener with a finished gold look is required.