NUVO Lighting 60-7458 Perkins, 1-Light, Wall Sconce, Matte Black with Burnished Brass

Yes, within limits. The Perkins 60-7458 carries a damp location rating and is listed for indoor use, so it works in a bathroom where it will not take direct water. NUVO classifies it under vanity and wall fixtures, and it mounts to a standard wall box. Keep it clear of the shower spray zone; a damp rating is not a wet rating.

It takes one standard A19 lamp with a medium E26 base, rated up to 60W at 120V. No bulb is supplied, so order lamps separately. The fixture itself is incandescent technology, meaning it is a socket fixture rather than integrated LED, so an LED A19 retrofit drops right in.

No. The Perkins 60-7458 is not ADA compliant, and with a 7.875 inch projection it exceeds the 4 inch limit for objects mounted between 27 and 80 inches above the floor on an accessible route. For corridors, stairwells, and other circulation paths, specify an ADA sconce instead. It is fine for guest rooms, bathrooms over a vanity, and other locations outside the accessible route.

Dimming depends entirely on the lamp you put in it. There is no driver in the fixture, so an incandescent or a dimmable LED A19 on a compatible dimmer will dim; a non-dimmable LED will not. Match the dimmer to the lamp you choose, not to the sconce.

It carries a cULus safety listing, which covers both US and Canadian requirements, so it satisfies the usual listed-fixture requirement on a commercial spec. Note the fixture does contain lead as a CA Prop 65 listed chemical, which matters if you are shipping into California.

No. It is rated for indoor, damp locations only, not wet. A covered porch exposed to blowing rain needs a wet-rated exterior fixture. Keep the Perkins to interiors and sheltered damp spaces like baths.

The body is steel in a matte black finish with burnished brass accents, weighing 2.71 lbs. A steel fixture at under three pounds mounts off a standard wall box without added support, and there are no glass shade parts listed to replace. For multi-family turns, the socket is a plain E26, so maintenance is just a bulb swap.

It ships with 72 inches of wire, which is far more than a typical box-to-fixture splice needs, so there is plenty of slack to trim to length in the box. Wiring is 120V, single lamp.

The Perkins 60-7458 is sold in one finish only: matte black with burnished brass. If you are standardizing finishes across a building, that is the single combination this model number covers.