NUVO Lighting 60-7767 Adina 1-Light Small Pendant, Matte Black and Natural Brass Finish

The Adina small pendant hangs to a maximum overall height of 51.5 inches using the supplied rods: two 6 inch rods and two 12 inch rods, plus 12 feet of wire. Combine or omit rods to set the drop. The fixture body itself is 12.5 inches high and 10 inches wide, so over a kitchen island or counter you can work back from your ceiling height to the rod stack you need.

It is rated for damp locations and listed for indoor use, so a bathroom or a laundry room is fine. A covered exterior porch is not covered by a damp indoor rating. For open or wind-driven exposure you need a wet-rated outdoor fixture instead.

No bulb ships with it. The socket is an E26 medium base taking a single A19 lamp at up to 60 watts, 120 volt. Buy the lamps separately if you are ordering these for a multi-unit job.

Dimming depends entirely on the lamp you install, because the fixture is a plain incandescent-technology socket with no integral driver. Drop in a dimmable A19 (incandescent or a dimmable LED replacement) and a standard 120V dimmer controls it. A non-dimmable LED lamp will not dim no matter what switch is on the wall.

Rod and stem mount to the ceiling. It uses rigid rods to set the drop, with 144 inches (12 feet) of supply wire run through them. If you need a swag or cord-hung look, or you are mounting to a sloped ceiling without a canopy adapter, this rigid-stem configuration is the wrong choice.

The fixture weighs 3.7 pounds, well inside the 50 pound limit of a standard listed ceiling outlet box, so no fan-rated or heavy-duty bracing is needed. The body is steel.

It carries a cULus safety listing, which covers both US and Canadian installations, and it is RoHS compliant. Note the California Prop 65 disclosure for lead, which matters if you are submitting product data on a public or institutional project.

Each Adina small pendant is 10 inches wide, so a run of two or three over a typical island leaves plenty of gap between shades. It is a single-lamp fixture, matte black with natural brass accents in a transitional style, so ordering multiples is how you cover a wider counter rather than looking for a multi-light version of the same shade.

No. There is no CCT selector switch, because the light source is whatever E26 lamp you install. Color temperature is set by your bulb choice, which is actually useful on a fleet job: you standardize the lamp across every fixture type in the building.