NUVO Lighting 62-1725 Blink Pro, 13W, 9in, LED Fixture, CCT Selectable, Square Shape, Black Finish, 120V

It carries a Wet location rating, so it can go in damp and wet spots like a shower ceiling or a covered porch soffit. Note the fixture itself is classified for indoor use, so the wet rating covers bathrooms, laundry rooms, and sheltered ceilings rather than fully exposed outdoor exposure.

It is a ceiling-mounted flush fixture, not a recessed can, so it surface mounts to the ceiling over a standard outlet box. At 0.67 inch high and 9 x 9 inches square it sits essentially flat against the ceiling, which is why these get used in closets, stairwells, and low-clearance corridors where a can housing won't fit above the plane.

The 13W Blink Pro is CCT selectable, so the color temperature is chosen at the fixture during install rather than by ordering a specific Kelvin version. That's the practical advantage for a property manager standardizing a fleet: one part number stocked, set to whatever the rest of the corridor or unit is already running. Light output lands in the 1032 to 1150 lumen range depending on the CCT setting selected.

Yes, the fixture is dimmable and runs on 120V line voltage. The LED is integrated, so dimming performance is governed by the driver inside the fixture rather than a replaceable lamp.

No. It is an integrated LED, with the board and driver built into the fixture, so there is no socket and no lamp to change. Rated life is 50,000 hours, after which the whole fixture is replaced. For maintenance planning that means no relamping line item, but a fixture swap at end of life.

At 13W it puts out 1032 to 1150 lumens, which is in the range of a typical 75W incandescent, with a 90 CRI for color rendering. It's a reasonable one-for-one swap for a small utility ceiling fixture in a closet, bath, hallway, or entry. For a larger room or a four-foot fluorescent troffer replacement, you'd want multiple units or a larger fixture.

Yes. The safety listing is cETLus, which covers both US and Canadian requirements, so it can be specified on jobs either side of the border. The fixture also carries a California Prop 65 notice for lead.

The base is die-cast aluminum, which also serves as the heat sink for the LED board. It is an edge-lit design in a utility style, black finish, weighing 1.46 lbs, so ceiling anchoring is straightforward even in drywall. Safety listing is cETLus, and the fixture is RoHS compliant.

Square, 9 x 9 inches, in a black finish. That is the only finish offered on the 62-1725; the round and other-size Blink Pro fixtures carry different part numbers.