NUVO Lighting 65-843 LED Area Light Type III, 150W, Bronze Finish, 5000K, 120-277V

Yes. The 65-843 ships with a 2-3/8 inch slip-fitter mount, which is the standard tenon size on most square and round poles and on pole-top adapters. No other bracket is included, so if your pole has a drill-pattern arm mount rather than a tenon, you'll need a tenon adapter to use the slip-fitter.

Yes. The 65-843 has a universal 120V-277V driver, so the same fixture works on 120, 208, 240 or 277 volt building power. That makes it practical to standardize one part number across a property where lot poles are 277V and a building-mounted unit is on 120V.

Wet location rated and cULus certified, so it is good for open-air pole and bracket mounting with no overhead cover. The housing is die-cast aluminum in a bronze finish.

Type III throws light forward and to the sides in an asymmetric pattern, which suits poles set along the edge of a drive lane, a parking row, or a perimeter where you want the light pushed out into the lot and kept off the property line. For poles in the middle of a lot needing light on both sides, a Type V (square/round, all directions) pattern is the usual choice instead. The 65-843 is the Type III, 150W, 19,736 lumen version.

At 19,736 delivered lumens from 150 watts, the 65-843 is in the range normally used to replace a 400W metal halide or high pressure sodium shoebox, where lamp lumens drop sharply over life. The LED is rated 50,000 hours average, so relamping trips go away.

The 65-843 is dimmable, so it can be driven by a compatible 0-10V type control or paired with a scheduling/dimming system to cut output overnight. No photocell or control device is included with the fixture; the only included hardware is the 2-3/8 inch slip-fitter.

The 65-843 is fixed at 5000K with 80 CRI, a cool daylight white typical of parking and security lighting. It is not CCT selectable, so there's no field switch to drop it to 4000K or 3000K. If your existing lot fixtures are 4000K, this unit will read noticeably bluer next to them.

The fixture weighs 8.08 lbs and measures 20.71 x 12.4 x 3.11 inches (length, width, height). That low weight and slim profile keep pole loading modest compared with an HID shoebox of the same output, which matters if you are reusing existing poles.

No lamps to order. It is an integrated LED fixture with the board and driver built into the housing, so there is no socket, no bulb base, and nothing to relamp. When the LED assembly reaches end of life the fixture is replaced, not re-lamped.

Yes. The 65-843 carries a California Proposition 65 notice for lead. It is also RoHS compliant. If your project documentation requires Prop 65 disclosure, list lead as the identified chemical.