NUVO Lighting TP216 Pendant Loop Track Adapter, Black Finish

The TP216 is a pendant loop adapter that goes into the track in place of a fixture head, giving you a loop to hang a cord or chain pendant from. It's the track-side piece, not the pendant itself, so you order it alongside the pendant you're hanging. It runs on 120V track and carries a cETLus safety listing.

No. The TP216 is a 120V line voltage track component. If your track runs 12V or 24V low voltage, this adapter is the wrong part and you need a low voltage pendant adapter matched to that system.

Indoor dry locations only. The TP216 is rated for dry locations, so it's out for a covered porch, a carport, or anywhere it sees moisture or condensation. A shower area or an enclosed pool room needs damp or wet rated gear instead.

It measures 3.5 inches high by 1.44 inches long by 1.44 inches wide, so it occupies a footprint under an inch and a half along the track run. That matters when you're spacing multiple pendants on one track and want to know how close together the heads can sit.

The adapter itself weighs 0.09 lbs, so it adds essentially nothing to the load. What it does is transfer your pendant's weight into the track, which means the track run and its mounting into the ceiling structure are what actually carry the fixture. On a heavy pendant, check that the track is fastened into joists or blocking rather than drywall anchors alone.

Black is the only finish offered on the TP216. If your track and pendants are white or brushed nickel, you'd be matching a black adapter against them, so look for the equivalent pendant adapter in your finish instead.

A track pendant adapter drops into the live track channel and twists to lock, no hard wiring at the ceiling, so it's a swap a maintenance tech can make with the circuit off. The TP216 is a 120V line voltage component, so treat the track as live until it's switched off at the breaker.