nVent CADDY CDY8P Push-In Conduit Clamp, 1/2"

nVent CADDY CDY8P Push-In Conduit Clamp, 1/2"

The nVent CADDY CDY8P Push-In Conduit Clamp is a 1/2" trade size clamp engineered for fast, tool-free conduit mounting on commercial and industrial electrical jobs. Its push-in design lets installers secure conduit runs to structural surfaces without a separate fastening step, cutting installation time on the jobsite. As part of the nVent CADDY line of conduit support and fastening products, this clamp is built to keep raceway systems properly aligned and supported throughout rough-in and finish work. Electrical contractors running repetitive conduit-support tasks across a jobsite benefit from a clamp that installs quickly and consistently, run after run, without stopping to pick up a driver or wrench for every point.

Key Features

• Trade Size: Sized for 1/2" conduit, matching standard raceway runs on commercial and industrial electrical installations.
• Push-In Installation: Tool-free push-in design speeds up conduit mounting and reduces installation steps compared to traditional screw-down clamps, so there is no separate driver or wrench needed at each support point.
• Secure Conduit Support: Holds 1/2" conduit firmly in place to maintain proper alignment and support along the raceway run once it is pushed into position.
• Time-Saving Design: Push-in mounting helps electricians move through repetitive conduit-support tasks faster during rough-in, which matters most on jobs with many support points to set.
• Consistent, Repeatable Fit: The push-in clamp action is designed to seat the same way at every mounting point, helping installers keep conduit runs uniform along a wall or ceiling run.
• nVent CADDY Engineering: Backed by nVent CADDY's line of electrical support products designed for demanding, repetitive jobsite use across commercial and industrial projects.

Technical Specifications

• Refer to manufacturer documentation for complete technical specifications.

Typical Applications

• Commercial and Industrial Electrical Installations
• Conduit and Raceway Support Systems
• Rough-In Wiring on New Construction Projects
• Renovation and Retrofit Electrical Work
• General Electrical Contractor Installations

Why nVent CADDY?

nVent CADDY is a recognized name in electrical support and fastening products, and the CDY8P Push-In Conduit Clamp reflects that focus on practical, installer-friendly design. Choosing nVent CADDY for 1/2" conduit support helps electrical contractors keep raceway systems properly secured and aligned throughout commercial and industrial projects, from initial rough-in through final inspection. For electricians who set large numbers of conduit supports on a single job, a clamp built around fast push-in installation is a straightforward way to keep the work moving without sacrificing a secure hold on the conduit.