You may also like
nVent CADDY ERC CATCR50 Cable Support Ring
The nVent CADDY ERC cable ring is built to support and route low-voltage and Category-rated cabling through open ceiling and wall cavities in commercial and industrial construction. As a specialty cable management component, this ERC-series cable ring helps electricians and low-voltage installers keep cable runs organized, elevated off other building systems, and protected from mechanical damage. Detailed dimensional, material, and load-rating data for this specific model were not published with this product listing, so installers and estimators should confirm exact specifications against nVent CADDY's official product documentation before ordering, bidding, or installing this component on a job site.
Key Features
- Cable Ring Configuration: This model's designation identifies it as a cable ring, a support style used to cradle, elevate, and route bundled low-voltage cabling above finished surfaces.
- Category Cable Compatibility: The CAT prefix in this ERC model's designation reflects intended use with Category-rated data and communications cabling common in structured cabling and telecommunications systems.
- nVent CADDY Manufacturing: Produced by nVent CADDY, a brand associated with cable fastening, support, and management hardware for commercial, industrial, and institutional electrical work.
- Model-Specific Reference: Match this exact ERC cable ring model designation when cross-referencing installation instructions, load data sheets, and compatible mounting accessories in nVent CADDY's published documentation.
- Specification Availability: Specific dimensions, base material, finish, and load ratings were not included in the source data provided for this listing and should be confirmed prior to specification.
Technical Specifications
- Refer to manufacturer documentation for complete technical specifications.
Typical Applications
- Structured Cabling Installations
- Commercial and Industrial Cable Runs
- Data and Communications Cable Support
- Ceiling and Wall Cavity Cable Routing
- Low-Voltage Cable Management Systems
Why nVent CADDY?
nVent CADDY designs cable support and fastening products used by electrical and low-voltage professionals to keep installations organized, orderly, and easier to service over time. This ERC-series cable ring carries the same model-specific identification approach so contractors and estimators can match it to the correct nVent CADDY installation guidance, load data, and mounting accessories for a given project.
Manufacturer Resources
Product Specs
- list_batch:
- CDY-20260915
- Product Type:
- Cable Ring
- Department:
- Electrical
- Product Group:
- Conduit & Raceway
- Product Subgroup:
- J-Hooks & Bridle Rings