OATEY 42723 2 in. ABS Floor drain with P-Trap and Cleanout

Solvent weld. The 42723 is an ABS body sized for 2 inch pipe, so the outlet is cemented to ABS DWV pipe with ABS solvent cement. There are no threads on the connection and no gasket, so you need a dry, deburred pipe end and a clean socket at glue-up.

No. The 42723 is a floor drain with the P-trap built into the body, so it arrives as one assembly that drops in and glues to the 2 inch ABS line. Running a second trap below it would create a double trap, which is a code violation in most jurisdictions.

It gives you rodding access into the trap without cutting the floor. On the 42723 the cleanout is part of the drain body, so a plugged trap or a line stoppage downstream can be cleared through the drain itself. That matters most in a mechanical room or laundry area where the drain sits in a slab and there is no other access for a hundred feet of pipe.

It is catalogued as a general purpose drain orientation, meaning it is not a specialty shower or area drain but a standard floor drain for indoor service areas: laundry rooms, utility and mechanical rooms, garages, basements. With a 2 inch outlet it sizes to the typical residential and light commercial floor drain branch.

Go cast iron where the drain takes vehicle or cart traffic, high-temperature discharge, or where the jurisdiction requires non-combustible DWV material in a given construction type. The 42723 is an ABS plastic body, so it is meant for standard residential and light commercial floor drainage, glued into an ABS DWV branch, not for heavy point loading on a finished commercial floor.

Oatey model 42723, UPC 038753427232. One configuration only: 2 inch ABS, solvent weld, black, with the P-trap and cleanout built in. There are no size or finish options to specify on this one.

The body is black ABS. It is supplied as the floor drain with an integral P-trap and cleanout on a 2 inch solvent weld outlet; if you want a specific decorative or stainless strainer face, that is a separate selection.