SATCO Lighting S11472 8.5W, BR30 LED, 4000K, 80 CRI, Medium Base, 120V, Dimmable, 6-Pack

It is the direct physical swap: same BR30 shape, same medium base, same 120V line voltage, at 8.5 watts of draw. Check that your fixture or dimmer is LED compatible, since incandescent-era dimmers were built for a much larger load.

The S11472 is a dimmable BR30 LED on 120V line voltage. It needs a dimmer rated for LED loads; older incandescent-only dimmers are the usual cause of flicker or limited dimming range at the bottom end.

4000K is neutral or cool white, a clean light with no yellow cast. It suits offices, kitchens, garages, corridors, and retail where you want alertness and accurate task visibility. If you are after the warm yellow tone of an old incandescent in a living room or bedroom, 4000K will read too cold, and the 80 CRI rating means color rendering is fine for general use but not for color-critical work.

The S11472 ships as a 6-pack, one part number covering all six lamps. That is the quantity property managers and MRO buyers usually want for relamping a run of cans in one pass.

It will match other 4000K lamps on color temperature, which is the part the eye notices across a ceiling. Mixing 4000K with 3000K or 2700K in the same room or corridor run reads as an obvious mismatch, so relamp by zone and keep one temperature per space. For the BR30 cans themselves, the 8.5W S11472 is the single part number to carry.

Frost. The diffused frosted face softens the source so you do not get hot spots or visible diodes looking up into a recessed can.