SATCO Lighting S11585 11W PAR30LN LED, Medium Base, Silver Finish, CCT Selectable, 120V, 25 degree Beam Angle

One lamp covers five color temperatures: 2700K, 3000K, 3500K, 4000K and 5000K, selected on the lamp itself rather than by ordering a different part number. That is why it is useful for MRO stock, one SKU covers a warm residential lobby at 2700K and a 4000K back-of-house corridor. Set the selection before the lamp goes up into a high can, since you will not want to pull it back down to change it.

Yes. The S11585 carries a wet location rating and is listed for both indoor and outdoor use, so it can go in soffit cans, covered entries and exterior accent housings as well as interior fixtures. The lamp body is polyamide with a clear polycarbonate lens.

A 25 degree beam is a narrow flood, meant for accenting, so it is the right choice over artwork, retail merchandise, signage or a reception desk where you want a defined pool of light. For even ambient coverage across a room it is the wrong tool, you would want a wider flood beam. With 1000 lumens pushed into 25 degrees, center beam intensity is high and spacing matters more than it would with a wide flood.

It is a dimmable lamp on 120 volt, 60 Hz line voltage. As with any LED retrofit, a dimmer built for incandescent load may flicker or drop out at the low end because an 11 watt lamp draws a fraction of the old 75 watt load, so an LED-rated dimmer gives better low-end performance. Nothing about the lamp requires a driver change.

CRI is 90, which is the threshold most retail, gallery and hospitality specs call for when color rendering matters on merchandise, skin tones or finishes. Paired with the selectable 2700K through 5000K range, you can match the lamp to the room's existing color scheme rather than reorder.

Burning position is universal, so base-up in a recessed downlight, base-down in a pendant, or horizontal in a track or wall-wash head are all acceptable. No orientation restriction to work around.

No. It is not a three-way lamp. Screwed into a three-way socket it will light, but only at full output, the two lower steps will not function. For stepped output you need a lamp specifically built as three-way, or put this one on a dimmer instead since it is dimmable.

Average rated life is 25,000 hours. On a 12 hour per day schedule that is roughly 5.7 years of service, which is the main reason facilities crews move accent cans in high ceilings and exterior soffits off incandescent, the ladder trips drop away.

The housing is silver with a clear lens, which reads as a bright metallic finish in an open track head or an unshielded trim where the lamp body is visible. If your existing heads carry black or white bodied PAR30s, the silver will stand out. Inside a baffled recessed can the body is hidden and the finish is immaterial.

Order it as Satco S11585. Each lamp weighs 0.24 lb, and it is made in Thailand. For distributors building an order, the medium base, silver finish, 25 degree, CCT selectable combination is what distinguishes this number from the wider beam and fixed-CCT lamps in the same PAR30LN family.