You may also like
SATCO Lighting S29454 15W, PAR38 LED, 5000K, 60 degree Beam Angle, Medium Base, 120V
15 Watt - PAR38 LED - 5000K - 60 deg. Beam Angle - Medium base - 120 Volt
Manufacturer Resources
Spec Sheet
Product Specs
- Amps:
- 0.125A
- Avg Rated Hours:
- 25000
- Burning Position:
- Universal
- CA Web Text:
- Lawful for sale
- CCT Selectable:
- No
- CRI:
- 90
- DLC Approved:
- No
- Dimmable:
- Yes
- Enclosure Rating:
- Enclosed Rated Lamp
- FCC Compliant:
- Yes
- Housing Color:
- Silver
- Lamp Base:
- Medium
- Lamp Filament:
- LED
- Lamp Shape:
- PAR38
- Lens Finish:
- Clear
- Lens Material:
- Thermo Plastic (PBT)
- Lensed:
- Yes
- Lumens:
- 1200L
- Operating Frequency:
- 60Hz
- Product Type:
- PAR
- Subcategory:
- LED
- Technology:
- LED
- Three-Way:
- No
- Warranty:
- 3 Year Limited - 12 hr per day
- Product Group:
- Indoor Lighting
- Product Subgroup:
- Light Bulbs
- Incandescent Equivalent:
- 90W
- Location Rating:
- Wet
- Base Material:
- Plastic
- Location Indoor/ Outdoor:
- Indoor;Outdoor
- Product Voltage:
- 120V
- Beam Spread Angle:
- 60
- Light Temperature:
- 5000K
- Product Category:
- Light Bulbs
- Product Wattage:
- 15W
- Product Weight:
- 0.49 lb
- Product Material:
- Plastic
Satco Lighting S29454 – Frequently Asked Questions
1) Can the Satco S29454 PAR38 LED go in an enclosed fixture?
Yes. The S29454 is an enclosed rated lamp, so it can run inside a sealed or gasketed fixture without the heat trap shortening its life. That matters for jelly-jar fixtures, sealed can lights, and covered outdoor housings where a non-enclosed-rated LED fails early.
2) Is the Satco S29454 PAR38 rated for outdoor use in exposed soffits and canopies?
It carries a wet location rating and is listed for both indoor and outdoor use, so exposed soffits, canopies, and open flood housings are in scope. Burning position is universal, so aiming it straight down at a parking area or straight up as an uplight are both acceptable.
3) What incandescent PAR38 flood does the 15W Satco S29454 LED replace?
It replaces a 90W incandescent PAR38 at 15 watts, putting out 1200 lumens. On a 120V circuit it draws 0.125A, so on a 20A branch circuit the lamp load per fixture is a fraction of what the halogen floods were pulling, which is what lets a retrofit add fixtures to an existing circuit.
4) Will the Satco S29454 screw into a standard PAR38 can light socket?
It uses a medium base, the standard Edison screw socket that halogen and incandescent PAR38 floods already sit in, so no socket change is needed. The base material is plastic rather than metal. It runs on 120V at 60Hz line power, so it is a direct lamp swap and not a driver or fixture replacement.
5) Does the Satco S29454 dim, and is it a fixed color temperature?
Dimmable, and fixed at 5000K daylight. There is no CCT selection switch on this lamp, so if a facility standardizes on warm 2700K or 3000K in lobbies and guest areas, this is the wrong lamp for those rooms. Buy it where you want a cool, daylight-white output.
6) Will the Satco S29454 PAR38 match the color of the other 5000K lamps in my building?
Color temperature is 5000K with a CRI of 90, so it lands in the daylight range alongside other 5000K lamps. Where it can look different is next to a standard 80 CRI LED: at 90 CRI, colors under this lamp read fuller, so a mixed row can show a visible difference in how surfaces look even though both lamps are nominally the same white.
7) Can I put the Satco S29454 on a three-way lamp socket?
No. It is a single-level lamp with no three-way circuit, so in a three-way socket it will run at one output regardless of switch position. For a three-way table or floor lamp you need a lamp built with a three-way base circuit.
8) Does the Satco S29454 qualify for a DLC utility rebate?
It is not a DLC approved product, so it will not qualify under utility programs that pay off the DesignLights Consortium qualified products list. If the rebate is part of how the project is funded, confirm the program accepts non-DLC screw-in lamps before you specify it.
9) How long does the Satco S29454 PAR38 last before relamping?
Average rated life is 25,000 hours. On a canopy or exterior fixture running dusk to dawn, roughly 12 hours a night, that is on the order of five to six years between relamps, which is what makes the ladder time on high or exterior mounts worth costing out against a cheaper lamp.
10) What does the lens and housing on the Satco S29454 look like installed?
Clear lens in thermoplastic PBT with a silver housing. The clear lens means you see the light source through the face rather than a diffused white glow, so in a low, open trim where the lamp face is visible it reads brighter and more direct than a frosted PAR would.
11) Can the Satco S29454 be sold and installed in California?
Yes, the S29454 is lawful for sale in California, so it can be specified on California work. It is also FCC compliant, which matters where lamps sit near sensitive electronics or communications gear.
How fast can I get the Satco Lighting S29454 delivered?
Most orders ship the same day from our distribution partners, with quick delivery throughout the
continental
U.S.
Need it urgently? Contact Us for expedited shipping options.
Can I return it if it doesn’t work for me?
Yes—ZenSupply offers a hassle-free return policy. If the product isn’t the right fit,
reach out to our support team for a return authorization or setup a return by following our return instructions.
Does the Satco Lighting S29454 come with a warranty?
Absolutely. The Satco Lighting S29454 is backed by a manufacturer’s warranty.
For full warranty terms, check the product documentation or Contact Us.
How do I get technical support or installation help for the Satco Lighting S29454?
You can call, text, or email our expert support team for fast answers. We’re here to help with
product
selection,
installation tips, and troubleshooting. Contact Us
Why buy the Satco Lighting S29454 from ZenSupply?
ZenSupply makes it easy to get the commercial door hardware you need—fast shipping, expert support,
and
rewards on
every order.
Our team is always ready to help you choose the right product for your project.