SATCO Lighting S9729 7.5W LED Downlight Retrofit, 4in Baffle, 3000K, GU5.3 socket for MR16 retrofit, 12V

No, not directly. The S9729 is a 12 volt retrofit with a GU5.3 socket connector, so it drops into a 4 inch can that already has an MR16 low-voltage setup with a transformer feeding it. If your can has a standard line-voltage medium base socket, this is the wrong part; you need a 120V retrofit module instead. Check what is in the can before ordering, because the two are not interchangeable.

3000K is the fixed output on the S9729, a warm white. There is no field-selectable CCT on this unit, so what you order is what you get. If the rest of your openings are 2700K or 4000K, this will read visibly different in the same sightline. For a fleet of units across a property, standardize on one temperature and confirm the existing lamps before you mix.

The S9729 is dimmable. What decides whether it actually dims smoothly is the low-voltage transformer feeding it, since a 12 volt LED module pulls a fraction of the load a halogen MR16 did and many magnetic transformers have a minimum load they need to see. Match the dimmer to the transformer type, and expect that a dimmer set up for halogen MR16s may need swapping to an LED-compatible model.

The S9729 carries a wet location rating, so it holds up in a shower, over a tub, or in a covered soffit where it sees moisture. Satco lists it as an indoor product, so the practical read is wet-rated indoor use, including damp bathrooms and laundry rooms, rather than fully exposed exterior mounting.

Yes, the S9729 is Title 24 compliant, which matters for residential and multi-family work in California where high-efficacy lighting is required in the permitted spaces. It is also RoHS compliant and FCC compliant. Those are the compliance items Satco publishes on it.

The LED is integrated. There is no separate lamp to buy and none to replace later, which is the tradeoff on a retrofit module: 35,000 average rated hours out of the unit, then the whole module comes out. For a property manager, that changes the relamping plan from a bulb swap to a fixture swap, but pushes the interval out considerably compared with halogen MR16s.

Baffle trim, in white with a frosted lens. The baffle rings cut glare, which is why it gets specified in corridors and living spaces where people look up into the ceiling. White and frosted is the only finish combination offered on the S9729.

Aluminum base construction on the S9729, which is what carries the heat away from the LED in a closed can. Keep insulation off the module body and leave the can's own vents clear; the 2.91 inch height is the depth you need available behind the ceiling plane for it to sit properly.

Satco publishes both for the S9729. The installation instruction sheet is at assets.satco.com under products/S9729, and the full photometric and electrical spec sheet is at media.satco.com/specsheets/pdf/S9729.pdf. Pull the spec sheet if you are submitting on a job and need the published data in the package.