Metallics JSE4 Screw Eyes 2-5/...
IN STOCK (leaves warehouse same day if ordered before 3pm ET)
$52.63
$3.39

Metallics JSE4 Screw Eyes 2-5/8 x 3/4 St-zn (JAR 100)

(No reviews yet) Write a Review

Model: JSE4
Selected Model is

In Stock (leaves warehouse same day if ordered before 3pm ET)

$52.63
$3.39
Adding to cart… The item has been added
Free Shipping on orders over $199
We price match and offer bulk discounts! Click Add to Quote. It's quick and easy.
✨
Earn points with this purchase! You can redeem points for giftcards, iPads, XBox's and more. View Rewards
Free Keying on all locks
Screw Eyes 2-5/8 x 3/4 St-zn (JAR 100)

Manufacturer Resources

Product Specs

Division:
Electrical H1
Pack Type:
Jar
Product Group:
Fasteners
Sub Division:
Electrical-E H2
Department:
Electrical
Product Subgroup:
Screws

Metallics JSE4 – Frequently Asked Questions

1) What do electricians use screw eyes like the Metallics JSE4 for?
Screw eyes thread into wood framing and give you a closed loop to run support wire, drop chain, or a tie point through. On electrical work that usually means hanging or guying lightweight runs and fixtures off joists and studs. The JSE4 is a wood-thread fastener, so it needs a wood substrate, not masonry or steel deck; for concrete or block you would want an anchor-type eye bolt instead.
2) Are zinc plated steel screw eyes OK for outdoor or damp locations?
The JSE4 is steel with zinc plating, which is a mild corrosion coating meant for dry interior work. For wet, exterior, or corrosive locations, use a stainless or hot dip galvanized eye instead, since zinc plating will eventually rust through in standing moisture.
3) Is JSE4 the actual part number I order by?
Yes, JSE4 is the Metallics manufacturer part number, and it is the single model offered for this 2-5/8 x 3/4 zinc plated screw eye. Distributors cross-referencing should quote it as Metallics JSE4.
4) Do I need to pre-drill for these screw eyes?
In hardwood or anywhere near the end of a board, drill a pilot hole smaller than the shank so the wood does not split; in soft pine you can usually start it by hand and finish by turning the eye with a screwdriver shaft or nail through the loop. The JSE4 has no driver recess, the eye itself is the handle.
How fast can I get the Metallics JSE4 delivered?
Most orders ship the same day from our distribution partners, with quick delivery throughout the continental U.S. Need it urgently? Contact Us for expedited shipping options.
Can I return it if it doesn’t work for me?
Yes—ZenSupply offers a hassle-free return policy. If the product isn’t the right fit, reach out to our support team for a return authorization or setup a return by following our return instructions.
Does the Metallics JSE4 come with a warranty?
Absolutely. The Metallics JSE4 is backed by a manufacturer’s warranty. For full warranty terms, check the product documentation or Contact Us.
How do I get technical support or installation help for the Metallics JSE4?
You can call, text, or email our expert support team for fast answers. We’re here to help with product selection, installation tips, and troubleshooting. Contact Us
Why buy the Metallics JSE4 from ZenSupply?
ZenSupply makes it easy to get the commercial door hardware you need—fast shipping, expert support, and rewards on every order. Our team is always ready to help you choose the right product for your project.