Klein Tools 85614 Screwdriver Set, Electronics Slotted and Phillips, 5-Piece

No. The 85614 set is not insulated and will not protect against electrical shock, so it has no place on energized work. If you need to work live, you need a VDE-rated 1000V insulated screwdriver instead. These are bench and equipment drivers for small screws on de-energized gear, and Klein warns against using them to pry or chisel.

Five drivers: two 1/8 inch (3.2 mm) cabinet tips, a 3/32 inch (2.4 mm), a 1/16 inch (1.6 mm), and a #0 Phillips. The two 1/8 inch slotted drivers differ in shank length, one 6 inch and one 4 inch, so you get the same tip in a short reach and a long reach. A carrying case is included.

They are not. The 85614 drivers are non-magnetic, which matters if you are working around hard drives, magnetic sensors, tape heads, or relay contacts where stray magnetism causes problems. The tradeoff is that you cannot use the tip to retrieve a dropped screw from a chassis, so keep tweezers or a pickup tool handy.

The screwdrivers themselves are made in the USA; the carrying case is made in China. Country of origin on the set is listed as United States, which is the detail to cite if you are buying against a domestic-preference or Buy American purchasing requirement.

Order Klein Tools 85614. That single model number covers the complete 5-piece slotted and Phillips electronics set with the carrying case, so there are no size or configuration choices to make on the order.

A #0 Phillips is sized for the small screws found on electronics boards, low-voltage terminal blocks, and thermostat subbases. If you are mostly driving the larger #1 and #2 Phillips screws on device plates, switches, and receptacles, this set is too small for that work and you want a standard electrician's screwdriver instead. Keep the 85614 for the fine stuff.

Yes, each driver in the 85614 set has a rotating cap, so you can hold the cap steady with a fingertip and spin the Cushion-Grip handle for controlled turns on small screws. The tips are heat-treated and precision ground. Handles carry color-coded rings and hot stamped cap markings so you can pick the right size out of the case without reading the shank.

The set ships as a 5-piece kit measuring 12.75 x 6.75 x 2.25 inches and weighing 0.8 lbs. That footprint is wider than most bag pockets, so it rides better laid flat in a service case or van drawer than stuffed into a pouch. The drivers come out of the case easily if you only need one or two on a call.